A LED Quanta Q290 Ceiling LED Light Instruction Manual
- June 9, 2024
- A LED
Table of Contents
A LED Quanta Q290 Ceiling LED Light
Important: Please read the instruction manual carefully prior to installation and keep it for future reference.
Ordering Code
| Product| Power (W)| Function Description
---|---|---|---
Fitting Series
| | | Sensor DIM,
Brida Sensor CCT Hvid / Sort| Brida| 18| color temperature selectable, power
switchable
Mounting: Wall or Ceiling Light features:
Ra: >80
Life Time: 5 years
Light Source: LED SMD2835 Input: 220V-240V 50/60Hz
CCT
Accessories
Colour Temperature Code
Code
|
Colour Temperature
|
CCT(K)
| Lumen
---|---|---|---
Hvid| Sort
30K| Warm White| 3000| 2070| 1980
35K| Natural White| 3500| 2160| 2030
40K| Cool White| 4000| 2196| 2070
Installation
- Unscrew the diffuser anticlockwise. Vertically remove the diffuser and PCBA.
- Cut off the power. Thread the input cable through the rubber plug to the fixture. Connect the L, N wire referring to the wiring diagram.
- Knock the rawl plugs into the pre-drilled holes on ceiling /wall.
- Wear plastic washers on self-tapping screws and tighten them to fix the fixture on ceiling/wall.
- Contact an authorised technical service centre for any repairs possibly required use only original spare parts.
- Do not touch LED while installing or maintaining.
- Sealing the entrance hole with glue after install is needed.
- The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.
Instruction for Light Source Disassembly
- Unscrew the diffuser anticlockwise and vertically take it out.
- Disconnect the DC power cable from the driver.
- On the reverse of diffuser, use the screwdriver to pry the clips to release the PCBA, then twist the PCBA anticlockwise.
- Take out the PCBA (light source) from the diffuser.This product contains a light source of energy efficiency class
- Install the cable clip.
- Connect the DC cable.
- Mount the diffuser onto the base with screws.
- Install the plastic plugs to hide the screws.
Wiring
Sensor Setting Options
Detection Pattern
Maintenance
- Cut off the main power first.
- Don’t touch LEDs while maintaining or cleaning.
- Don’t use chemicals to clean the fixture.
Environmental protection: waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your local authority or retailer for recycling advice.
Caution
- The product must be installed by professional technicians and power supply must be cut off before installation.
- The diameter for AC input wire is 0.75mm² (complying with 60245 IEC57), which complies with the latest IEE electrical standards or national standards.
- Do not touch the electronic circuit and its components.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>