Kurdene N06-A Environmental Noise Cancelling Earbuds User Manual

Kurdene N06-A Environmental Noise Cancelling Earbuds User Manual

Using Instructions

Choose the ear cap that suits you.

Put the earbuds into the ear in the angle shown as the picture above.

Gently rotating the earbuds to a comfortable position.

Error
demonstration

• The earbuds will automatically turn on after opening the top lid of the charging case.
  OR

• Press and hold the touch button for 5 seconds, then leave hold, the earbuds will turn on.(Not in the charging case and is in the off state)

• Put the earbuds into the charging case and close the lid, they will automatically shut down.
  OR

• While in the non-working state, press and hold the touch button for 6s, the two earbuds will be turned off at the same time.
  OR

• Automatically shut down after not connected for more than 5 minutes

Warm notice
For any single earbud, when it is in standalone mode, you can’t use it to play the previous song or decrease the volume.

First time using

1. Tear off the insulating film. Put the earbuds into the charging case and close the lid to charge(the earbuds are in charging state).
   

2. Open the cover of the charging case and take out the two earbuds,they will turn on and pair automatically and will be prepared for pairing to the phone.
   
   Warm notice: If the earbuds are not turned on or there is no sound come out, please put them back in the charging case again to make sure that they are in the charging state before taking them out for use (red/white light flash alternately)

3. The indicator of one earbud will go off and another will flash red and white light alternately.(In pairing mode)

4. Turn on the Bluetooth function on your phone and search for 1N06-A] and connect it.
   
   Warm notice
    If indicators of both earbuds keep flashing red and white, Click either earbud’s power switch twice. Then the indicator of one earbud will flash red and white alternately, another will go off. (in pairing mode)

Restore factory setting

1. Please turn off the bluetooth of the mobile phone. When the red and white lights of the two earbuds are blinking, press the earbud 4 times quickly. The earbud will shut down after the reset is successful.

2.  Delete the old pairing name on the Bluetooth terminal of the mobile phone and connect the earbud after it is turned on.
   

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>