smartwares SH4-99578 Wireless Switch Set Instruction Manual
- June 9, 2024
- smartwares
Table of Contents
smartwares SH4-99578 Wireless Switch Set
Specifications
Remote control (SH4-90151)
- Battery: 3VDC, type CR 2032 (incl.)
- Radio Frequency: 433.92Mhz
- Maximum output: 0dBm
- Maximum range: 30m
EU plug (SH4-99578)
Maximum power: 2300 W
AC input Voltage : 230V ~ 50Hz
CE
smartwares Europe
Jules Verneweg 87 5015 BH Tilburg The Netherlands
www.smartwares.eu
PREPARATION BEFORE USE
Insert battery
-
Open the battery lid at the back of the remote (1) by turning it counter clockwise.
-
Insert the battery with the negative polarity downward.
To check if the battery is inserted correctly, briefly press a button on the remote. If the LED flashes, then the battery is inserted successful. -
Insert the receiver into the wall outlet.
NOTE: The socket-outlet must be installed close to the equipment and must be easily accessible.
PAIRING THE REMOTE TO THE RECEIVER
- Press the button on the receiver (2) for 3 seconds. When the LED starts to blink, the receiver is in pairing mode.
- Press any of the ON buttons on the remote. If the LED stops blinking and is constantly lit, the pairing was successful.
OPERATING RECEIVERS
- Press the ”ON” button on the remote control to turn on the receiver.
- Press the “OFF” button on the remote control to turn off the receiver.
- Press the ”ON” button beneath ALL (on the remote control) to turn on all paired devices at the same time.
- Press the ”OFF” button beneath ALL (on the remote control) to turn off all paired devices at the same time.
Disconnecting a remote
- Press and hold the button on the receiver for 3 seconds (3) and then release it. During this operation the LED starts to blink. Your receiver is now switched into the pairing mode. Attention: the LED should blink only after releasing the button. If the LED starts to blink while holding the button, there will be no pairing.
- Perform one of the following steps:
- Press an ”OFF” button on the row on the remote you wish to disconnect from a receiver. During this operation the LED on the receiver blinks quickly and then turns off.
- Press the ”OFF” button next to ALL (on the remote) to disconnect all links. During this operation the LED on the receiver turns off.
- To remove all pairing memories on the receiver:
- Press and hold the button for more than 6 seconds (3).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>