PHILIPS DH2X24 DIN Rail Enclosure Instruction Manual
- June 9, 2024
- Philips
Table of Contents
DH2X24 DIN Rail Enclosure
Instruction Manual
Devices must be installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations.
DH2X24 DIN Rail Enclosure
De-rate total load current of each Philips Dynalite controller to 70% of its
rated value.
Rated voltage not to exceed 400 V. Rated current not to exceed 125 A. The
enclosure complies with IEC/EN 60670-24.
Prospective short-circuit current not to exceed 10 kA unless protected by
current limiting device with a cut-off current not exceeding 17 kA.
© 2022 Signify Holding. All rights reserved. Specifications are subject to change without notice. No representation or warranty as to the accuracy or completeness of the information included herein is given and any liability for any action in reliance thereon is disclaimed. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. All other trademarks are owned by Signify Holding or their respective owners.
AZZ 503 0922 R07
www.dynalite.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>