ZUMA ZMSD-01 Switching Dongle Instruction Manual
- May 15, 2024
- ZUMA
Table of Contents
ZUMA ZMSD-01 Switching Dongle
Dongle Wiring
Do not connect the Zuma Switching Dongle to the mains power.
The Zuma Switching Dongle does not need a power feed to work.
The Zuma Switching Dongle should only be wired to an unpowered rocker switch.
The switch the Zuma Switching Dongle is wired to should not be connected to
any mains power.
The Zuma Switching Dongle cannot be used in a 2-way, 3-way or N-way setup.
The Zuma Switching Dongle can only be used with the main Zuma Lumisonic.
Installation
- Ethernet – currently only a service port*
- Dongle connections for the switch wires.
- Dongle USB-C connector to attach to main Zuma unit.
- Zuma unit DC power jack.
- Zuma unit USB-C connector.
Warranty
This product is an accessory of Zuma Lumisonic. Please refer to the product
documentation for the relevant declarations and safety warnings.
Failure to adhere to these conditions will risk invalidating the warranty.
The time period of your warranty will be determined by your original point of
purchase. Please refer to your original point of purchase for additional
information.
In the event that Zuma Array Ltd has diagnosed the product as damaged or
faulty, please refer to your original point of purchase to make a warranty
claim. For all warranty claims, you will need to provide proof of purchase.
For additional warranty information, please visit
www.zuma.ai
To review your warranty coverage, please visit www.zuma.ai. © 2021 ZUMA Array Limited or its affiliates. Zuma and all related logos are trademarks of Zuma Array Limited or its affiliates.
The registered office of Zuma Array Limited is: 5 Garden Walk, London, United Kingdom, EC2A 3EQ.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>