ZUMA Flush Mount Adapter Installation Guide
- June 9, 2024
- ZUMA
Table of Contents
ZUMA Flush Mount Adapter
Introduction
Thank you for purchasing your Zuma Flush Mount Adapter (Round).
Here you’ll find a quick guide to help you get started. Enjoy!
You will need #3 plasterboard screws 12cm hole saw
Drilling holes
Begin by using a pad saw to cut a squares with 11cm sides in your ceiling where you intend to install your Zuma Flush Mount adapters.
Insert the Flush Mount Adapter
Bring the Flush Mount Adapter to the ceiling and carefully push it into the
hole.
Screw into the ceiling
Using #3 plasterboard screws, secure the Flush Mount Adapter to the ceiling.
Ensure there is some batten inside of the ceiling for the screws to grip onto.
Plaster the ceiling
Apply a plaster skin the the ceiling to cover the mounting face.
Remove the plug
Once the plaster skin has set and the ceiling has been painted, remove the
protective plug and discard.
You are now ready to install your Zuma unit.
Please refer to the Zuma Installer Guide for instructions on how to install
your Zuma unit.
Install the Zuma unit
Refer to the Zuma Installer Guide for instructions on how to install your Zuma unit.
Flush Mount Adapter – Square
To review your warranty coverage, please
visit www.zuma.ai. 2021 ZUMA Array Limited or its
aftiliates.
Zuma and all related logos are trademarks of Zuma Array Limited or its
afiliates.
The registered office of Zuma Array Limited is:
5 Garden Walk, London, United Kingdom, EC2A 3EQ.