HAVIT Lighting HV9658 IP66 Constant Voltage LED Driver Instruction Manual

: June 9, 2024
: Havit Lighting

Table of Contents

HAVIT Lighting HV9658 IP66 Constant Voltage LED Driver
Dimensions
Important Safety Issues
Steps for Installation
Read User Manual Online (PDF format)
Download This Manual (PDF format)

HAVIT Lighting HV9658 IP66 Constant Voltage LED Driver

HAVIT-Lighting-HV9658-IP66-Constant-Voltage-LED-Driver-
product Product Specifications

Product Specifications

Dimensions

HAVIT-Lighting-HV9658-IP66-Constant-Voltage-LED-Driver-
fig-1

Important Safety Issues

This product must be installed by a qualified electrician according to AS/NZS 3000.
Ensure all electrical mains are disconnected before any installation.
Modification of this product will void any warranty.
Havit Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
Aluminum and 304SS fittings must not be installed within 5km of any saltwater environments.
All Havit Lighting LED Drivers are provided with a flex & plug for ease of replacement if Driver was to fail. Removing this plug will void warranty.
The converter must only be connected by a fully qualified electrician.
Make sure has the correct output voltage to light source being installed.
The installer is responsible for proper installation according to safety regulations. The primary and secondary cables have to be selected considering type and wire gauge.
Load, cable length, voltage drop and terminal characteristics have to be taken into consideration.
Disconnect the LED Driver from the main power if its cables are damaged. – Damaged cables must be replaced.
LED Driver can become very hot during use, Do not cover.
The distance between the power supplies and the surfaces around must be min. 50mm so Driver is well-ventilated.
The power supply has connection cables on primary and secondary side. The secondary cables are multiple depending of the power class and are connected to the same potential. The load has to be divided to the connection cables equally. It is not permitted to take the complete load by one single output cable, alternatively, you can parallel the 2x output cables to have full power from one connection point.
This form may be updated at any time due to product improvements, please check the online installation form for most current version.

Steps for Installation

Connect the Output cable to the light source making sure that the polarity is correct. If the Driver has 2x Output cables, These can be joined to form one connection point.
If connections are outdoors make sure to cover connections using an adhesive-lined heat shrink or gel cap to make connections watertight. Failure to do this will void the warranty.
Make sure the power is off before connecting the 240v plug to PowerPoint, Once plugged in turn power back on.
When LED Driver is turned on and a ticking noise can be heard. This indicates a short on the run. Turn Driver off and inspect all connections before turning back on.