HAVIT Lighting HV5803T-WHT Nella 12W Surface Mounted LED Downlight Instruction Manual
- June 4, 2024
- Havit Lighting
Table of Contents
HAVIT Lighting HV5803T-WHT Nella 12W Surface Mounted LED Downlight
Product Specification
Dimensions
Important Safety
Issues
- This product must be installed by a qualified electrician according to AS/NZS 3000.
- Ensure all electrical mains are disconnected before any installation.
- Modification of this product will void any warrarnty.
- Havit Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
- Aluminium and 304SS fittings must not be installed within 5km of any salt water environments.
- All o-rings and seals must be in place correctly to maintain warranty
- This form may be updated at any time due to product improvements, please check online installation form for most current version.
Steps for Installation
- Make sure that the electrical circuit is free of voltage (master switch off)
- Remove the base plate by twisting anti-clockwise.
- Unplug fitting from the driver and set fitting aside
- Install base plate in desired location using appropriate screws for application. If fitting is installed in an outdoor environment, Seal must stay in place to keep fittings IP Rating.
- Connect the cable: Use wire with earth, connect earth first then positive and then neutral
- Reconnect plug from fitting to driver.
- Fitting is preset to 3000k, To change slide switch inside fitting to desired colour temperature
- Reattach fitting to base plate by twisting clockwise
- All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.
Must be installed by a licensed electrician
Warranty Terms & Conditions
Additional Information
Tel: 02 9381 8300
Fax: 02 9666 8881
143 Beauchamp Road
Matraville NSW 2036
Email: sales@havit.com.au
Australia
Web: www.havit.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>