HAVIT Lighting HV3633 Veldi Wall Light Instruction Manual
- June 4, 2024
- Havit Lighting
Table of Contents
HAVIT Lighting HV3633 Veldi Wall Light Instruction Manual
Important Safety Issues
- This product must be installed by a qualified electrician according to AS/NZS 3000.
- Ensure all electrical mains are disconnected before any installation.
- Modification of this product will void any warranty.
- Havit Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
- All 316 & 304 stainless steel fittings must have regular cleaning maintenance to avoid any tea staining from forming on fitting. (Warranty does not cover Tea Staining)
- All o-rings and seals must be in place correctly to maintain warranty
- This form may be updated at any time due to product improvements, please check online installation form for most current version.
Product Specifications
ccc
| HV3633T-BLK| HV3633T-WHT|
HV3633T-SS316
---|---|---|---
Name
| Veldi
Material|
316 Stainless Steel
Colour
| Black| White| Stainless Steel
IP Rating|
IP54
Protection Class
| 1 (240v Requires Earth)
Input Voltage|
240v AC
Lamp Base
| GU10
Lamp Wattage|
2x 5w
Colour Temp
| TRI Colour – 3000k, 4000k, 5500k
Lumens|
2x 250lm, 2x 275lm, 2x 300lm
CRI
| > 80
Wiring|
Parallel
Dimmable
| No
Warranty|
3 Years Replacement*
Dimensions
Mounting Base Diagram
Steps for Installation
- Make sure that the electrical circuit is free of voltage (master switch off )
- Remove screws from top and bottom of fitting and set aside.
- Remove base plate from fitting.
- Install base plate to wall in desired location using appropriate screws for application.
- Seal all holes including cable entry and around screws
- Connect the cable – use wire with earth; connect the earth first, then live and neutral wire.
- Fitting is preset to 3000k, to change remove globes and slide switched on side to desired colour temperature
- Reattach fitting to baseplate making sure screws are tight to avoid water penetration.
- Apply silicon around edge of fitting to prevent any water from getting inside to electrical connections.
- All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.
Steps for Changing Globe
- Remove cover from fitting by removing screws from top and bottom of fitting.
- Remove globe by twisting anti clockwise
- Insert new globe by twisting clock wise making sure to check correct globe is used – Refer product label for correct wattage
- Reattach fitting to base plate making sure screws are tight to avoid water penetration.
Must be installed by a licensed electrician
*Warranty Terms & Conditions
**
Contact Details:
143 Beauchamp Road
Matraville NSW 2036
Australia
Tel: 02 9381 8300
Fax: 02 9666 8881
Email: sales@havit.com.au
Web: www.havit.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>