Shenzhen Future Charger Technology HC01 Constant Warm Cup with Wireless Charger User Manual

Future Charger Technology HC01 Constant Warm Cup with Wireless Charger
User Manual
Constant warm cup with wireless charger

HC01 Constant Warm Cup with Wireless Charger

Please read the instructions before using the product

Parameter specification

• Model: HC01
• Input: 12V/1.5A
• Phone output: 15W Max
• Warm cup: 18 W Max
• Efficiency: ≥75%

Installation

1. Plug the power adapter into the socket.
2. USB cable ②connects the power adapter.
3. Put ③connects the USB-C Interface.
4. Put the device which supports wireless charging function on the launch plate correctly. Indicator light changes to green from blue if it starts to charge. The light will be blue if you remove the mobile phone, which means the wireless charging pad enters in a standby mode.

For mobile phone:

1. LED blue light: Standby
2. LED green light: Charging
3. Blue light flashing: Mobile phone location in deviation or over temperature protection or trigger FOD

For warm cup:

1. Green light breathing: the wireless charger is in thermal insulation state
2. Blue light flashing: after the continuous heat preservation working time is more than 4 hours, enter the power saving mode

Important notes

1. Please remove the protective case (except receiver case) when charging, to keep high efficiency. We suggest you use a 3A adapter for the best results.
2. Do not disassemble the charger or throw it into fire and water, to avoid causing a short circuit leakage.
3. Do not use wireless charger in severely hot, humid or corrosive environments, to avoid circuit damage and occurs leakage phenomenon.
4. Do not place stuff with magnetic strip or chip (ID card, bank cards, etc ) on wireless charging pad to avoid magnetic failure.
5. Please keep the distance at least 20 cm between implantable medical devices (pacemakers, implantable cochlear,etc.) and the wireless charger, to avoid potential interference with the medical device.
6. Please take care of the children and ensure they won’t play the wireless charger as a toy, to avoid unnecessary accidents.
7. It is better the mobile phones or other related machines don’t set the vibration mode,as the vibration will cause deviation and effect the charging experience.
8. Please read the manuals cal fully before charging,this product can not be ensured to be compatible with the functions of all the machines.

Warranty

There is one year guarantee for this product unless anthropocentric factor.
Packing List

• Constant warm cup with wireless charger

• User Manual

• Type-c Cable

• The involved images are sketch maps , the final product as per the material subjects.

FCC Warning Statement: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

FCC Radiation Exposure Statement
The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co‐located for operating in conjunction with any other antenna or transmitter.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>