BitWise Addressing Room Remote User Manual
- June 9, 2024
- BitWise
Table of Contents
Addressing Room Remote
User Manual
Introduction
Each Room Remote must be assigned a unique address. This prevents Room Remotes
in different rooms (or neighboring installations) from controlling unintended
activities.
See RF Receiver Layout for more information regarding rooms and addresses.
Enter Addressing Mode
Hold the OK and B buttons simultaneously until the red status LED comes on solid (approximately 3 seconds)
Enter The New Address
Enter a new three-digit address. Valid addresses range from 001 – 255.
Store The New Address
Press OK to store the new address. The red status LED will flash twice if successful. The LED will flash five times if an invalid address was entered or if the procedure times out.
Read User Manual Online (PDF format)
Loading......