amzchef BX2-H-J1EAM01 Range Hood Instruction Manual

amzchef BX2-H-J1EAM01 Range Hood

IMPORTANT SAFETY INSTRUCTIONS

Read all instructions before using this appliance. Save these instructions for future references Approved for residential appliances For residential use only

WARNING

1. Before servicing or cleaning unit, unplug or disconnect the rangehood from the power supply.
2. TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
   • Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.
   • Always turn hood ON when cooking at high heat or when flambeing food (i.e. Crepes Suzette, Cherries Jubilee, Peppercorn Beef Flambe’).
   • Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or filter.
   • Use proper pan size. Always use cookware appropriate for the size of the surface element.
3. TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:
   • SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT.
   • NEVER PICK UP A FLAMING PAN – You may be burned.
   • DO NOT USE WATER, including wet dishcloths or towels – a violent steam explosion will result.
   • Use an extinguisher ONLY if:
   1. You know you have a Class ABC extinguisher, and you already know how to operate it.
   2. The fire is small and contained in the area where it started.
   3. The fire department is being called.
   4. You can fight the fire with your back to an exit. a Based on “Kitchen Firesafety Tips” published by NFPA.
4. To Reduce The Risk Of Fire Or Electric Shock, Do Not Use This Fan With Any Solid-State Speed Control Device.
5. To provide protection against electric shock, connect to properly grounded outlets only.

CAUTION: For General Ventilating Use Only. Do Not Use To Exhaust Hazardous Or Explosive

• Check to ensure your electricity supply matches that shown on the rating plate.The appliance must only be used as rated.
• Please always supervise children and any other individuals that should be monitored while using this appliance.
• Do not connect the air outlet to chimney fuels or combustion gas ducts.
• Do not leave unattended open flames under this hood.
• In case of any damage to power cable, replace the broken cable with a new one by a qualified professional.
• Clean the hood as instructed in this manual. If the hood is not cleaned or cleaned improperly, it may cause fire, or the range hood may function incorrectly.
• The LED lamp should be replaced by a qualified professional. Always use a 1,5W LED light or less.
• Do not wash the control switch with water, as it will cause elec-trical issues for the range hood.
• Do not pull the plug from the power supply with wet hands to avoid electrical shock.
• Disconnect the hood from the power supply if the appliance will not be used for an extended period of time.

STAINLESS STEEL BAFFLE FILTERS

About Your New Filters
Stainless Steel Baffle Filters do not need linings or mesh inside of the filters and are completely constructed out of stainless steel. The stainless steel construction allows them to be used again after being cleaned or going through the dishwasher

How do Baffle Filters Work?
They function by forcing the grease frilled air to quickly and continuously change direction as it passes through the filter. The grease is unable to change direction as fast as the air carrying them, they end up getting caught on the metal blades and then trapped into the filter tray.These filters are both efficient and require less maintenance.

PARTS DIAGRAM

BX2-H-J1EAM01

BX2-H-J1EAM02

PARTS INCLUDED

PARTS LIST

• A. 12pcs-St6.0 screws
• B. 12pcs-Wall Anchors
• C. 1pcs-Remote Control

PARTS NEEDED

PRE-INSTALLATION REQUIREMENTS

1. Do not install the Range Hood where there are many doors or win- dows in order to avoid affecting the exhaust efficiency caused by air convection.
2. Install the Range hood directly above the cooking surface. The recommended distance between the cooking surface and the bottom of the range is a minimum of 24″ and a Maximum of 30″.
3. In order to get the optimum performance, do not extend the vent pipe too far , adjust the vent pipe, and make sure the hood is level and vertical.
4. The air outlet must not be connected to chimney flues or combustion gas ducts. The air outlet must not be connected to ventilation ducts for rooms in which fuel-burning appliances are installed.

SAFETY WARNING
HOOD MAYA VE SHARP EDGES; PLEASE WEAR PROTECTIVE GLOVES FITS NECESSARY TO REMOVE ANY PARTS FOR INSTALLING, CLEANING, OR SERVICING.

INSTALLATION INSTRUCTIONS

WARNING

1. TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK.
2. GROUNDING INSTRUCTIONS
   This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.

WARNING – Improper grounding can result in a risk of electric shock. Consult a qualified electrician if the grounding instructions are not completely understood, or if doubt exists as to whether the appliance is properly grounded.
Do not use an extension cord. If the power supply cord is too short, have a qualified electrician install an outlet near the appliance.

CAUTION
To reduce risk of fire and to properly exhaust air, be sure to duct air outside – Do not vent exhaust air into spaces within walls or ceilings or into attics, crawl spaces, or garages. Use only with rangehood cord-connection kits that have been investigated and found acceptable for usewith this model rangehood.

1. 1.Drill two 8mm holes in position for Wall Anchor (Part B) placement (See Page 5 for placement location).
2. Tap Wall anchors securely into each of the drilled holes.
3. After Wall anchors have been tapped in place, Insert st 6.0 Screws, but leave 1/4of the screw sticking out of the wall. (This will give your Range Hood something to hang onto).
4. Take the hood unit along with the 6Round Aluminum duct (Part D). Secure the round aluminum duct to the vent hole at the top of the hood unit using HVAC Aluminum foil tape. If mounting to a cabinet, skip step 5 and proceed with steps 6-11.
5. LF mounting to the wall only, drill a 6-1/4 round hole on the back wall above the hood, OR into the ceiling directly above the hood. 5a. Remove bafle filters from underneath the hood and set them aside. 5b. Lift the hood and hang the hood unit on the back wall using the screws drilled in Step 3. Once the hood is securely hung on the wall, tighten the screws from the interior of the hood. 5c. Pull round aluminum duct through the newly drilled hole in the wall. Plug unit into power outlet. Reinstall baffle filters.
6. Drill a 6 – 1/4Round Hole into the bottom of the cabinet. Drill a 1 – 1/2hole into the bottom of the cabinet for the Electrical Access hole. See Page 5 for hole location according to the diagram (Top View).
   • Pull the round duct & power cord through the bottom of the new cabinet holes.
7. Lift the hood and hang the hood unit on the back wall using the screws drilled in Step 3.
8. Once the Hood is hung to the back wall, Remove the baffle filters from underneath the hood.
9. rill each of the five pieces of st 6.0 screws (Part C) into the bottom of the cabinet using the five screw holes at the top of the hood.
10. Once the hood is secured into the cabinet, tighten the wood screws located in the back of the hood. Install Baffle filters back into place. Make sure hood is secure by pressing on it. Plug unit into power outlet.

COMPATIBLE WITH MODELS: BX2-H-J1EAMO01

Push Button Controls

How to use the Push Button:

0 Off button
It’s used for turning off the fan.

Low-Speed button
It’s used for Ventilation on the kitchen. It is suitable for simmering and cooking which do not make much steam.

Medium Speed button
Airflow speed is ideal for ventilation in standard cooking operations.

High-Speed button
When a high density of smoke or steam is produced, press the high-speed button for the highest effective ventilation.

Light button

Soft Touch Controls

COMPATIBLE WITH MODELS: BX2-H-J1EAM02

Before using the remote control please Remove the battery film!

STANDBY MODE.
After plug in, just is flashing slowly, the system is in STANDBY MODE.

“ON/OFF” key:

• In STANDBY MODE press to enter to WORKING MODE, display & all buttons light on. If it is the first time to start up, the motor will work at LOW speed, the lights will be off automatically, or the hood will recover from the same set of the last working operation. (Same for in Remote control)
• In WORKING MODE, press , motor stops working, but the light will keep the status.
• In WORKING MODE, press & hold for 3 seconds, Motor & light stop working, and the unit will be back to STANDBY MODE. ( Same for in Remote control with the short press) All other buttons just could work in WORKING MODE

“FAN SPEED” key

Button for changing the speed of motor following cycle “Low-Middle-High”. (This key could not stop motor working.) (Same for in Remote control)

“Light” button
Short Short press for lamp on/off. & hold for 1 second, the “88:88” flashing & enter the

CLOCK SETTING

In STANDBY MODE, press + CLOCK SETTING MODE.
In this state: pressing for changing selecting hour or minute pressing key for decrease. pressing key for increase
If press + key or without any operation in CLOCK SETTING MODE for 5 seconds, it will save the setting automatically and exit CLOCK SETTING MODE.

TIMER SETTING

In , press & hold for 1 second, display flashing shows “00:00”, enter the

TIMER SETTING MODE.
In this state: pressing for increase 15 minutes pressing for decrease 1 minute. pressing ****for increase 1minute.

If press key or without any operation in TIME SETTING MODE for 5 seconds, it will save  the setting automatically and start to count down showing in display. When time elapses, both motor & light will turn off automatically & come back to STANDBY MODE.

Cleaning Symbol
When the power is turned on for the first time or the motor has been working for 14 hours, the cleaning symbol will be lit as a reminder for cleaning the filter. Long press the ” ” button to clear the cleaning symbol, the buzzer will beep twice, and the timing will restart.

LCD display:

1. Fan symbol, will be displayed when the fan is working
2. Time display
3. Timer
4. Light
5. Fan speed
6. Cleanning symbol.appear when total working time up to 14 hours

MAINTENANCE

CAUTION: Never put your hand inside the unit while it is operating. For the best performance clean your unit frequently.

CLEANING:

1. Use only mild soap or cleaning solutions to clean the range hoods outer surface. Dry sufaces using a soft cloth.
2. Stainless Steel cleaner may be used on the external surface.
3. Cleaning the Baffle Filters: For daily cleaning, use hot, soapy water and a soft cloth. Wipe dry and finish with a damp micro- fiber cloth. Bafile filters can also be cleaned in the dishwasher.
4. Clean the Range Hood assembly once every 6 months.
5. DO NOT clean motor or electrical components with water or any other liquid.

REPLACING LIGHT BULBS

CAUTION: LED LAMP UNIT IS HOT! WAIT BEFORE ATTEMPTING TO REPLACE LED LAMPS. PLEASE BE SURE THE UNIT IS POWERED OFF AND UNPLUGGED.

NOTE: INDIVIDUAL LED BULBS CANNOT BE REPLACED. ONLY LED LAMPs.

1. Remove the baffle filters
2. Find the wire connection of the lamp and unplug.
3. Remove old LED lamp.
4. Plug in new LED lamp.
5. Reinstall the baffle filters.

TROUBLESHOOTING

CAUTION: ALWAYS TURN OFF POWER AND UNPLUG THE APPLIANCE BEFORE TROUBLESHOOTING.

debris and remove it

My range hood has poor performance.

| A.   The range hood and cooktop are too far away from each other. Optimal distance is 24″ to 36″

B.    There are too many open windows or doors in the area.Close some doors or windows.

C.    The motor performance has decrease. Replace motor.

D.Check and make sure the tape holding down the damper flaps at the vent hole are removed before use.

My range hood shakes.

| A.  The installation is not secure. Check again and make sure the installation hardware is securely mounted.

B.  The fan is broken or not balanced.Realign or replace fan.

C.   The motor is loose.Check and make sure the motor is solidly mounted to the unit.

The motor no longer runs.| Replace with new motor assembly.
Light bulb went out.| Replace with a new1.5W LED lamp.

TECHNICAL INFORMATION

For motor accessory

A| Motor| 1
B| Fan blower| 1
C| Iron volute components| 1
D| Iron volute air inlet net cover| 2

WARRANTY

Thank you for choosing AMZCHEF product. We sincerely hope that you are satisfied with it. The manufacturer’s warranty covers the product for a period of 12 months from the date of purchase against manufacturing faults. All warranties are automatically kept track of in our system, so there is no need to register your product. Agent/Distributor is welcome to contact us. Email:info@iamzchef.com. Any help or questions during use, please contact us via website www.iamzchef.com, send email to info@iamzchef.com, or scan our related QR Codes herein for quick service, we will service you within 24 hours. We suggest to provide a warranty card, a photo or a video if there’s broken spare part or not working machine so that we can be much more clear about your problems and offer you the best solution.

Please fill in the table and email it within 10 days from the date of purchase.

References

• Amzchef US | Slow Juicer | Induction Cooker | Chopper

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>