KLUS FI-8-PRET-Z Fastener Instruction Manual

KLUS FI-8-PRET-Z Fastener Instruction Manual

Mounting Instructions

***** The full range of accessories and electronics is available at www.KlusDesign.eu

NOTE! All LED tapes must be connected to a 12 V or 24 V power supply.

IMPORTANT: Not all possible mounting procedures are presented here. More mounting procedures and related accessories can be found at www.KlusDesign.eu. Drawings of extrusions and accessories in these instructions are simplified and only approximate the actual shapes.

1. Drill holes in the ceiling where You will install the fasteners.
   

2. Put pads (3.4, 3.5) into the holes from the top and insert the threaded sleevs (3.10) with nuts (3.6), connectors (3.7), locking washers (3.8) and nuts (3.9) mounted.
   

3. Put the pads (3.3) on the sleeves from the bottom and tighten them to the ceiling with fastener bodies (3.1). Tighten and lock all the items in the upper part of the fastener.
   

4. Lead the rods (2) through fastener bodies and threaded sleeves to the other side of the fastener. Lock the power supply cables in the connectors (3.9).
   

5. Suspend the fixture (1), adjust the length of the rods, so the fixture hangs evenly. Tighten the pressure screws (3.2) in the fastener bodies. Power supply cables must be connected to a 12 V / 24 V  Power supply (4).
   
   

Customer Service

For further Information, please visit:  https://klusdesign.eu

References

• Shapes | Suomalaista laatutyötä yli 30 vuoden kokemuksella | shapes.fi

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>