Satel ART-200 Wireless Radiator Thermostat Installation Guide
- June 2, 2024
- Satel
Table of Contents
Satel ART-200 Wireless Radiator Thermostat
Quick installation guide
Full manual is available onwww.satel.pl. Scan the QR
code to go to our website and download the manual.
The device should be installed
by qualified personnel.
Before installation, please read the full manual thoroughly.
Changes, modifications or repairs not authorized by the manufacturer shall
void your rights under the warranty.
There is a danger of battery explosion when using a different battery than
recommended by the manufacturer, or handling the battery improperly. Do not
crush the battery, cut it or expose it to high temperatures (throw it into the
fire, put it in the oven, etc.).
Do not expose the battery to very low pressure due to the risk of battery
explosion or leakage of flammable liquid or gas.
Be particularly careful during installation and replacement of the
battery.
The manufacturer is not liable for the consequences of incorrect
installation of the battery.
The used batteries must not be discarded, but should be disposed of in
accordance with the existing rules for environment protection.
The device is designed for indoor installation. The ART-200 radiator
thermostat’s place of installation must be located within the radio range of
the ABAX 2 controller. Thick walls, metal partitions, etc. will reduce the
range of the radio signal. Use the ARF-200 tester to check the level of radio
signal. Place the tester next to the valve on which you want to install the
thermostat. If the radio signal level indicated by the tester is higher than
40%, you can install the thermostat there. The thermostat is fitted for
radiator valves with the M30 x 1.5 mm threaded connection. It is compatible
with most radiator valves on the market. In order to install the thermostat on
the Danfoss RA valve, use the supplied adapter.
- Use your fingers to press down the symbols on both sides of the battery cover (gray element on Fig. 1). Pull to remove the cover.
- Install two 1,5 V LR6 AA alkaline batteries (they are not supplied with the thermostat).
- Add the thermostat to the wireless system (see ABAX 2 controller manual).
- Replace the battery cover.
- Install the thermostat on the valve.
- Press or . The calibration will begin.
- Configure the thermostat settings
Hereby, SATEL sp. z o.o. declares that the radio equipment type ART-200 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:www.satel.pl/ce
Customer Support
SATEL sp. z o.o. • ul. Budowlanych 66 • 80-298 Gdańsk • POLAND
tel. +48 58 320 94 00
www.satel.pl
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>