Satel ART-200 Wireless Radiator Thermostat Installation Guide

: June 2, 2024
: Satel

Table of Contents

Installation Instructions
Documents / Resources

Satel ART-200 Wireless Radiator Thermostat

Installation Instructions

Full manual is available on www.satel.pl. Scan the QR code to go to our website and download the manual.

| The device should be installed by qualified personnel.
Before installation, please read the full manual thoroughly.
Changes, modifications or repairs not authorized by the manufacturer shall void your rights under the warranty.
There is a danger of battery explosion when using a different battery than recommended by the manufacturer, or handling the battery improperly. Do not crush the battery, cut it or expose it to high temperatures (throw it into the fire, put it in the oven, etc.).
Do not expose the battery to very low pressure due to the risk of battery explosion or leakage of flammable liquid or gas.
Be particularly careful during installation and replacement of the battery.
The manufacturer is not liable for the consequences of incorrect installation of the battery.
The used batteries must not be discarded, but should be disposed of in accordance with the existing rules for environment protection.
---|---

The device is designed for indoor installation. The ART-200 radiator thermostat’s place of installation must be located within the radio range of the ABAX 2 controller. Thick walls, metal partitions, etc. will reduce the range of the radio signal. Use the ARF-200 tester to check the level of radio signal. Place the tester next to the valve on which you want to install the thermostat. If the radio signal level indicated by the tester is higher than 40%, you can install the thermostat there.
The thermostat is fitted for radiator valves with the M30 x 1.5 mm threaded connection. It is
compatible with most radiator valves on the market. In order to install the thermostat on the Danfoss
RA valve, use the supplied adapter.

Use your fingers to press down the symbols on both sides of the battery cover (gray element on Fig. 1). Pull to remove the cover.
Install two 1,5 V LR6 AA alkaline batteries (they are not supplied with the thermostat).
Add the thermostat to the wireless system (see ABAX 2 controller manual).
Replace the battery cover.
Install the thermostat on the valve.
Press or . The calibration will begin.
Configure the thermostat settings.

Hereby, SATEL sp. z o.o. declares that the radio equipment type ART200 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:www.satel.pl/ce

SATEL sp. z o.o. • ul. Budowlanych 66 • 80-298 Gdańsk • POLAND
tel. +48 58 320 94 00
www.satel.pl

Documents / Resources

| Satel ART-200 Wireless Radiator Thermostat [pdf] Installation Guide
ART-200, Wireless Radiator Thermostat, Radiator Thermostat, Wireless Thermostat, Thermostat, ART-200 Thermostat
---|---
| Satel ART-200 Wireless Radiator Thermostat [pdf] Instruction Manual
ART-200 Wireless Radiator Thermostat, ART-200, Wireless Radiator Thermostat, Radiator Thermostat, Thermostat