satel HOOD A Protective Hood for Outdoor Detectors Installation Guide
- June 1, 2024
- Satel
Table of Contents
satel HOOD A Protective Hood for Outdoor Detectors
This document provides a visual guide for the installation of the HOOD A component as part of SATEL’s intelligent alarm systems. Below are detailed illustrations and instructions for proper assembly and installation.
Specifications
| Model | HOOD A |
|---|---|
| Part Number | hood_a_int 01/24 |
| Manufacturer | SATEL |
| Website | www.satel.pl |
Installation Steps
- Identify the HOOD A component and corresponding AGATE/AOCD-260 accessory.
- Prepare the HOOD A component by aligning it with the AGATE/AOCD-260 as illustrated.
- Slide the HOOD A component onto the AGATE/AOCD-260, ensuring a snug fit as indicated by the direction of the arrows.
- Secure the HOOD A component is held in place by pressing down firmly until it clicks into position, as demonstrated by the hand pressing on the illustration.
- Verify that the HOOD A component is securely attached and aligned correctly with the AGATE/AOCD-260.
Contact Information
- SATEL sp. z o.o.
- Ul. Budowlanych, 66
- 80-298 Gdańsk
- POLAND
- Tel: +48 58 320 94 00
FAQ
- Where can I find more information about HOOD A?
- You can visit the SATEL website at www.satel.pl for more information about HOOD A and other intelligent alarm systems.
- What should I do if HOOD A does not fit securely?
- Ensure that you are aligning the component correctly as per the illustrations. If the issue persists, please contact SATEL customer support for assistance.
- Is there a specific orientation for installing HOOD A?
- Yes, the illustrations in the guide depict the correct orientation. The HOOD A should slide onto the AGATE/AOCD-260 with the designated side facing downwards.
Installation instrction
CONTACT
- SATEL sp. z o.o.
- ul. Budowlanych 66
- 80-298 Gdańsk
- POLAND
- tel. +48 58 320 94 00
- www.satel.p
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>