elgato Light Strip User Guide
- June 2, 2024
- elgato
Table of Contents
elgato Light Strip
What’s In The Box
Mounting
-
The length of Light Strip can be adjusted to accommodate your chosen application. To shorten Light Strip, use a pair of scissors to bisect the silver solder joints (located at intervals of 33 cm | 13 in). Cutting along the indicated trim line will result in no electrical conductivity beyond that point.
Note: Disconnect Light Strip from power before shortening. -
Clean the mounting surface with a lint-free cloth. Peel back some of the protective film to expose a short section of the adhesive backing on Light Strip, and stick to the mounting surface by applying pressure for 5 to 10 seconds. Slowly peel back the remaining film with one hand while using the other hand to press down newly exposed sections of the adhesive backing. Once fully mounted, run your fingertips firmly along the full length of Light Strip to maximize bond strength. Use the additional tesa adhesive strips to mount the controller.
Installation
-
Download and install the Control Center app for Mac, Windows, i0S or Android.
-
Connect the LED strip to the controller. Then connect the controller to the power supply and plug it into a power outlet.
Note: After powering up, Light Strip will quickly color cycle and engage pairing mode.
-
Launch the Control Center app and pair Light Strip by clicking the + icon. Control Center will guide you through the setup process.
Note: For Wi-Fi pairing using a Mac, turn on your Light Strip, click the Wi-Fi icon in the top right Status menu, and select your new accessory. After completing the Airport Utility setup process, your Light Strip is accessible from Elgato Control Center.
-
Use Control Center to switch Light Strip on/oft, adjust brightness, fine-tune color, and set temperature. If your PC is not equipped with Wi-Fi, use the
Elgato Control Center app on your i0S or Android device to add Light Strip. AWi-Fi connection is only needed for initial pairing. Once paired, you can control Light Strip via any wired or wireless device in your network.
Reset
RESET will restore Light Strip factory settings and forget all Wi-Fi
credentials. Push and hold the RESET Button with a small tool for at least 10
seconds until the light flashes red 3x. Light Strip will reboot automatically
and color cycle before reengaging pairing mode.
Warning
- Light Strip may become hot during prolonged use. Always handle with care
- Light Strip is made for indoor use only.
- Do not cover this product, especially the controller
- Be especially cautious when setting up near children.
- Do not leave Light Strip in direct sunlight.
- Keep the lighting surface free from dirt and dust, If Light Strip becomes dirty, wipe it lightly with a soft cloth moistened with a little water and mild, neutral detergent. Benzene, thinner, and other volatile agents can cause permanent damage and should never be used for cleaning
- Do not use the product for applications other than those specified in this guide or the packaging.
- Do not use accessories other than those supplied with the product or stated as compatible by the manufacturer.
- Frequency range: 2412- 2472 MHz (2462 MHz for FCC, ISED), Max RF e.i.r.p power < 20 dBm,
- Temperature range: 0 °C – 45 °C. Hereby, Corsair Memory Inc. declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EC. The declaration of conformity for Elgato products is available at www.elgato.com/doc
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>