elgato Wave DX Dynamic Microphone User Guide
- June 4, 2024
- elgato
Table of Contents
elgato Wave DX Dynamic Microphone
Installation
Mount Wave DX on a stand or boom arm such as Wave Mic Arm or Wave Mic Arm LP. If necessary, use a coin to remove the pre-installed thread adaptors.
Use a shielded microphone cable with 3-pin XLR connectors to connect Wave DX to a preamp or audio interface such as Wave XLR.
Do not use 48V Phantom Power with Wave DX!
Using Wave DX
Speak into the end of Wave DX and keep a distance of approximately 8-12 cm I 3-5 in for optimal voice capture.
If for any reason you need to remove and reattach the mount, be sure to stack the socket set in the following order
Elgato, a division of:
Corsair Memory Inc., 115 North McCarthy Blvd, Milpitas, CA 95035, USA Corsair
Components Limited, 1020 Eskdale Road, Winnersh Triangle, Wokingham, RG41 5TS,
UK
Corsair Memory, BV Wormerweg 8, 1311 XB, Almere, Netherlands Copyrignt 20Z0-
2022 Corsair Memory Inc. All ights reserved. Elgato and the tlgato logo are
trademarkS of Corsair Memory Inc., registered in the U.S. and other countries.
Part: 51MAH9902
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>