PHILIPS PATPA dynalite Antumbra Touch User Manual
- June 2, 2024
- Philips
Table of Contents
PATPA
AntumbraTouch
User Interface Installation Instructions
PATPA dynalite Antumbra Touch
Devices must be installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations.
Federal Communications Commission (FCC) Compliance Notice: Radio Frequency
Notice – This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions,may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Reorient or relocate
the receiving antenna. Increase the separation between the equipment and
receiver. Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected. Consult the dealer or an experienced
radio/TV technician for help. Any modifications not approved by the
manufacturer of this device could void the user’s authority to operate this
device. This Class B digital apparatus complies with Canadian ICES-003: CAN
ICES-3(B)/NMB-3(B). Cet appareil numerique de la classe B est conforme a la
norme NMB- 003 du Canada: CAN ICES-3(B)/NMB-3(B).
Installation of a home and building automation and control system shall
comply
with IEC 60364 (all parts). The temperature limits and current-carrying
capacities forthe communication wires specified in IEC 60364-5-52 shall not be
exceeded.
© 2022 Signify Holding. All rights reserved. Specifications are subject to
change without notice. No representation or warranty as to the accuracy or
completeness of the information included herein is given and any liability for
any action in reliance thereon is disclaimed. Philips and the Philips Shield
Emblem are registered trademarks of Koninklijke Philips N.V. All other
trademarks are owned by Signify Holding or their respective owners.
Do not connect inputs to mains.
Disconnect power before connecting or separating modules.
Refer to Service Guide for full cleaning recommendations.
www.lighting.philips.com/dynalite
AZZ 457 0622 R21
Documents / Resources
|
PHILIPS PATPA dynalite Antumbra
Touch
[pdf] User Manual
PATPA dynalite Antumbra Touch, PATPA dynalite, Antumbra Touch, Patpa, dynalite
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>