blinds2go DuoLight Pearl EasiFIT Thermal Blind Installation Guide
- June 2, 2024
- blinds2go
Table of Contents
Installation Guide
EasiFIT Pleated Blinds
https://www.youtube.com/watch?v=knaxZI_bu2o&feature=youtu.be
We’ve made a handy video version of this fitting guide, just click the play
button to view it.
If you prefer to print the instructions or simply to follow step-by-step, just
keep reading.
Unpacking the blind and fitting the brackets
Allocate the brackets so that those with the ‘winged’ area to the right are used for the left hand side of the blind, and those with the winged area to the left are used for the right hand side of the blind.
- Place the transparent circular pads onto the back of each bracket.
- Then, clip the cord attachments onto the brackets.
Take care if using scissors or a knife to open the internal wrapping – make sure you do not cut the wrapping on the same side that the cords are stored.
Fitting the blind
Click the brackets into the window to complete the installation.
NB: The bracket fits under the rubber or Mastik seal so that it sits flush to
the glass area.
If the seal is quite stiff, apply a small amount of washing-up liquid to the
area that the brackets will be fitted to ease the installation.
The bracket should be pushed right under the frame, so that it’s flush with the bead (the edge of the glass area).
Fine-tuning the tension
The tension on the blind should be correct for your window size as soon as the
blind is fitted. However, if you find that the blind is a little loose and
slips down or is stiff to operate, you may want to adjust the tension.
This can be done without taking the blind down, just move the knot on the cord
along to the adjacent slot on the cord attachment. Move the knot to the outer
slot (away from the centre of the window) to tighten the tension, or to the
inner slot (towards the centre of the window) to loosen the tension.
While all four brackets allow for the tension to be altered, it’s rare that
all four would need adjusting. Adjust the bottom two knots first (always do
both to keep the tension even) then test the blind, the tension should now be
corrected. Only alter the position on the top brackets if further adjustment
is required.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>