strymon Flint Tremolo Effect Pedal User Guide

June 2, 2024
strymon

strymon Flint Tremolo Effect Pedal User Guidestrymon Flint Tremolo Effect
Pedal

KNOBS AND SWITCHES

KNOBS AND SWITCHES

TREMOLO TYPE
Switches between three tremolo types: ‘61 harm: harmonic band filtering that alternates low and high frequencies for a hypnotic effect ‘63 tube : a smooth volume pulsing created by modulating the bias point of the output tubes ‘65 photo : a sharper-edged volume effect achieved by using a photocell and light  dependent resistor

INTENSITY
Controls the intensity or depth of the tremolo effect.

SPEED
Adjusts the tremolo LFO frequency from slow to fast.

REVERB TYPE
Switches between three reverb types: B full-size two-spring tank typical of those found on vintage guitar amps ‘70s : electronic plate that uses multi-tap parallel delay lines with filtered feedback paths ‘80s: studio digital microprocessor rack hall reverb with modulating delay lines.

MIX
Controls the reverb wet mix from 100% dry at minimum to 100% wet with no dry signal at maximum. Set to 3 o’clock for 50/50 dry/ wet mix.

DECAY
Varies the reverb time. The ‘70s and ‘80s verbs approach ‘infinite’ decay at maximum.

COLOR
Varies the reverb tone from darker at low settings, to brighter at higher settings .

TREMOLO ON
Engages the TREMOLO. RED LED indicates effect is engaged.

REVERB ON

Engages the REVERB. RED LED indicates effect is engaged.

REAR PANEL CONNECTIONS

KNOBS AND SWITCHES

AUDIO INPUT SELECTOR
MONO:
Use with a mono input signal. Output is stereo.
STEREO: Use with a stereo input signal. Output is stereo.

IN
High impedance, ultra low-noise, discrete Class A JFET preamp input. TRS adapter cable required for stereo input signal.

OUTPUTS
Low impedance stereo audio signal outputs. Use OUT L for mono output.

USB-C
Computer connection for controlling via MIDI and firmware updates.

9VDC
Use the included power supply or an adapter with the following rating: 9VDC, center negative, 300mA minimum.

EXP / MIDI
Multifunction communication jack for external control of Flint’s features and functions. Use a standard TRS expression pedal for continuous control over the knobs of the pedal (default setting). See complete User Manual for details about configuring for MIDI communication or accessories such as Strymon Conduit, MultiSwitch Plus, and MiniSwitch.

Download the complete User Manual atstrymon.net/support/flint-v2

SAMPLE SETTINGS

SAMPLE SETTINGS
DREAMY WARM TREM
SAMPLE SETTINGS
SHORT POPPY TRE

SAMPLE SETTINGS

OCEAN WAVES

SAMPLE SETTINGS
VAPORIZE
SAMPLE SETTINGS
SLIDE ON OUT

LIVE EDIT FUNCTIONS

Flint provides a way to adjust several parameters that do not have a dedicated knob or switch. These are called Live Edit functions and details about utilizing and storing them are included in the complete User Manual. The sample settings on this page use the factory default values for these functions

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals