strymon Z120-COND Condit MIDI Hub User Guide
- June 6, 2024
- strymon
Table of Contents
strymon Z120-COND Condit MIDI Hub User Guide
WELCOME TO CONDUIT
GETTING STARTED
Conduit is a premium, easily configurable, ultra-reliable MIDI interface that
will work with most 1/4″ MIDI equipped effects pedals.
It also offers the best USB computer connection available for TRS MIDI pedals.
SMART MIDI DISTRIBUTION
Each of Conduit’s four bi-directional 1/4″ TRS jacks are independently configurable to work with a variety of 1/4″ MIDI communication modes. Enjoy easy configuration with no DIP switches, custom cables, or screwdriver required. Built-in ground isolation ensures the quiet operation you expect from Strymon. Link multiple Conduits to control additional 1/4″ MIDI pedals.
USB INTERFACE FOR YOUR PEDALS
Send MIDI control change messages from a sequencer to perfectly sync pedal parameter changes, automate pedal preset changes, load and save presets, or send SysEx messages—all from your computer.
CONTROLS AND CONNECTIONS
CONNECTING YOUR 1/4″ MIDI DEVICES TO CONDUIT
ADDITIONAL INFORMATION
USING CONDUIT WITH A COMPUTER
When USB is connected, the computer will recognize 6 MIDI I/O ports.
- Conduit MIDI Ports 1-4 correspond with the 1/4″ TRS jacks numbered 1-4.
- Conduit MIDI Port 5 corresponds with the 5-DIN MIDI IN/MIDI OUT ports.
- Conduit MIDI Port 6 will appear as a background USB communication port.
The diagram above shows how the MIDI ports corresponding to each of the devices connected to Conduit will show up in your computer/DAW.
FEATURES
- One opto-isolated 5-pin DIN MIDI interface (IN and OUT ports)
- Four 1/4″ TRS bi-directional MIDI ports
- Five MIDI status indicator LEDs
- One USB Type-C to USB-A Male cable
- Lightweight, compact anodized aluminum chassis with threaded mounting hardware
WHAT’S IN THE BOX
- Conduit MIDI hub
- Four (4) 18″ right-angle to straight TRS cables
- One USB Type-C to USB-A Male cable
- Drill Template
- Two (2) mounting screws
- Four (4) rubber feet
- Quick Start Guide
- Styron sticker
CONDUIT MOUNTING INSTRUCTIONS
Conduit features built-in threaded hardware for easy mounting on the top or
bottom of most pedalboards.
-
CHOOSE YOUR MOUNTING LOCATION
Tape the Drill Template (included in this box) logo side up in the location you want to install your Conduit.
This illustration shows mounting on the top of your pedalboard. -
DRILL HOLES
Drill through the two marked hole locations with a 1/8″ (3mm) bit. -
ATTACH CONDUIT
Place Conduit over the holes. Install from the reverse side of your pedalboard using the provided #4-40 screws (3/8″).
Have any questions? strymon.net/support/conduit <<
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>