VONN VAP2321 7 Inch 1-Light Integrated LED Pendant Lighting Fixture Instruction Manual
- June 3, 2024
- VONN
Table of Contents
VONN VAP2321 7 Inch 1-Light Integrated LED Pendant Lighting Fixture
TOOLS YOU MAY NEED
PARTS LIST
- A. Mounting Bracket x 1
- B. Outlet Screw x 2 + 1
- C. Wire Connector x 2 + 1
- D. Ground Screw x 1
- E. Canopy Cover Screw x 2
CIRCUIT BOX
LED INFO WARNINGS
- Please read and understand the entire manual before attempting to assemble, operate, or install the product.
- All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use any parts that are worn or broken.
- Please handle the LED light with care when unpacking. Do not apply pressure to the LEDs, do not open any factory-sealed compartments, and do not touch the LEDs with your hands.
- VONN recommends installing the fixture on its own independent circuit. Do not install the fixture on the same circuit with the other appliances, or HVAC systems.
- DO NOT CUT WIRES attached to the fixture under any circumstance. Cutting wires will VOID your warranty. Excess cables should be neatly looped and tucked into the canopy.
- Place the wall switch in the “OFF” position of the room you are installing the fixture.
- Make sure that you have all the necessary parts by checking the parts list. If any part is missing or damaged please contact VONN LIGHTING CUSTOMER SERVICE at 888-604-8666 for a replacement.
- Inspect the LED fixture prior to installation to make sure that it has not been damaged during shipping.
- VONN highly recommends using a qualified, licensed electrician to install the fixture.
- Do not remove or replace VONN manufactured parts that are provided with the fixture.
- VONN recommends ELV (Electric Low Voltage) type dimmers for this fixture.
- Shut “OFF” the electricity at the main fuse box.
Fixture Diagram
Instructions
Adjust Height
- The length of the cable is adjustable. To determine the proper length of the fixture, hold the fixture canopy up against the outlet box in the ceiling to adjust the cable.
- Depress the locking pin on the canopy, hold the pin in place, and pull down or push up on the cable. Repeat the step for each cable.
Installer Tip (1):
It is recommended that two installers are required to adjust the height of the
fixture. One installer to hold the fixture, and the second installer to adjust
the cables.
Install Mounting Bracket
Secure mounting bracket (A) with outlet screws (B).
Connect Wires
Supply Wires:
- Connect Black (Line Wire) from fixture to Black (Hot Wire) from the outlet box.
- Connect White (Neutral Wire) from fixture to White (Neutral Wire) from the outlet box.
Ground Wires:
Connect Bare Copper (Ground Wire) from fixture to Green or Bare Copper (Ground
Wire) from the outlet box. Twist wires together clockwise and secure with wire
connector (C).
Installer Tip (2):
If the ground wire is not available in the outlet box, then secure Bare Copper
(Ground Wire) from fixture to ground screw (D) on mounting bracket (A).
Installer Tip (3):
It is recommended that two installers are required to install the fixture. One
installer to hold the fixture, and the second installer to connect the wires.
Mount Fixture
Secure the canopy to the mounting bracket (A) with canopy cover screws (E).
Turn Power ON
Turn the electricity “ON” at the main fuse box. Place the recommended ELV-type dimmer switch in the “ON” position to test the fixture.
Circuit Box
www.vonn.com. © VONN Lighting, 2022.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>