VONN VAW1192 LIGHTING Tall LED Wall Sconce Installation Guide
- June 7, 2024
- VONN
Table of Contents
VONN VAW1192 LIGHTING Tall LED Wall Sconce
TOOLS YOU MAY NEED
GOGGLES
|
TAPE MEASURE
|
RUBBER GLOVES
---|---|---
PHILLIPS SCREW DRIVER
|
DRILL
|
LADDER
PARTS LIST
Mounting Bracket x 1
|
Outlet Screws x 3
|
Wire Connectors x 3
---|---|---
Ground Screw x 1
|
Canopy Screws x 2
CIRCUIT BOX
LED INFO & WARNINGS
Please read and understand the entire manual before attempting to assemble,
operate, or install the product.| Make sure that you have all necessary parts
by checking the parts list. If any part is missing or damaged please contact
VONN LIGHITNG CUSTOMER SERVICE at
888-604-8666 for a replacement.
---|---
All parts must be used as indicated in these instructions. Do not substitute
any parts, leave parts out, or use any parts that are worn or broken.| Inspect
the LED fixture prior to installation to make sure that it has not been
damaged during shipping.
Please handle the LED light with care when unpacking. Do not apply pressure to
the LED’s, do not open any factory sealed compartments, and do not touch the
LEDs with your hands.| VONN highly recommends to use a qualified, licensed
electrician to install the fixture.
VONN recommends to install the fixture on its own independent circuit. Do not
install the fixture on the same circuit with the other appliances, or HVAC
systems.| Do not remove or replace VONN manufactured parts that is provided
with the fixture.
Place the wall switch in the “OFF” position of the room you are installing the
fixture.
Shut “OFF” the electricity at main fuse box.| VONN recommends ELV (Electric
Low Voltage) type dimmers for this fixture.
Fixture Diagram
Step 1. Install Mounting Bracket
Attach mounting bracket (A) to outlet box with outlet screws (B).
Step 2. Connect Wires
Supply Wires:
Connect Black (Line Wire) from fixture to Black (Hot Wire) from outlet box.
Connect White (Neutral Wire) from fixture to White (Neutral Wire) from outlet
box.
Ground Wires:
Connect Bare Copper (Ground Wire) from fixture to Green or Bare Copper (Ground
Wire) from outlet box.
Twist wires together clockwise and secure with wire connector (C).
Installer Tip (1) : If ground wire is not available in outlet box, then secure Bare Copper (Ground Wire) from fixture to ground screw (D) on mounting bracket (A).
Installer Tip (2) : Supply wires can be either tucked into outlet box or fixture canopy.
Step 3. Mount Fixture
Step 4. Turn Power ON
Turn electricity “ON” at main fuse box.
Place the recommended ELV type dimmer switch in the “ON” position to test the
fixture.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>