superbrightleds com GL-C-001W RGB CCT RGBW RGBCCT LED Controller User Manual

: June 4, 2024
: superbrightleds com

Table of Contents

Safety and Notes
Controller Layout
- LED Indicator
- Reset
- Opt
- Wi-Fi Pairing
- Wiring
RF Remote (Optional Accessory)
- Pairing / Unpairing
Preprogrammed Display Modes
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

superbrightleds com GL-C-001W RGB CCT RGBW RGBCCT LED Controller

Safety and Notes

Do not connect controller directly to AC power. This controller requires 1254 VDC power supply. Voltage of power supply and any connected lights must match.
Do not exceed max current or wattage as listed in the spec table. Overloading the controller will cause overheating and damage the controller.
Ensure the power supply is not plugged into an outlet before connecting or disconnecting any of the systems components.
Do not expose the controller or remote to direct or indirect moisture.
Always observe proper polarity when connecting wiring.
Improper installation and magnetic fields will negatively affect the controller’s communication distance.

Controller Layout

Compatibility Mode| RGB- CCT| RGBW| RGB| CCT| Dimmer
---|---|---|---|---|---
Indicator Color| White| Yellow| Blue| Green| Red
Frequency| 600 Hz| 800 Hz| 1,000 Hz| 2,000 Hz| 4,000 Hz| 8,000 Hz
---|---|---|---|---|---|---
Number of Flashes| 1| 2| 3| 4| 5| 6

LED Indicator

LED indicator changes color to display with the current compatibility mode. Refer to the indicator color chart to the right.

Reset

Press once to switch frequency. Press and hold for 2 seconds to reset the controller. In order to be compatible with different power supplies, the frequency can be set to 600 Hz, 800 Hz, 1,000 Hz (default), 2,000 Hz, 4,000 Hz, 8,000 Hz. Each time the frequency is switched, the indicator light will flash pink a specific number of times to show which frequency is now being used.

Opt

Press to switch modes. Press and hold for 2 seconds to add the current ON/OFF state to memory.

Note: Each time the mode is switched, the controller will need to be re- paired.

Wi-Fi Pairing

Connect to a 2.4 GHz Wi-Fi network. Note: If device was already paired, please reset the device.
Apply power to the controller.
Open the Smart Life app to add the controller.
Follow the in app instructions.
If the pairing is sucessful, the indicator light will stop flashing

LED Controller and Remote

Wiring

RF Remote (Optional Accessory)

Pairing / Unpairing

Pairing
Within 4 seconds after applying power to the controller, press the “ON” button of the desired zone until pairing is successful.
Unpairing
Within 4 seconds after applying power to the controller, press the “ON” button on the remote control 5 times quickly.

Preprogrammed Display Modes

Available display modes vary depending on the selected compatibility mode. For example, RGB compatibility mode will not work with numbers 13 below.

Available display modes vary depending on the selected compatibility mode. For example, RGB compatibility mode will not work with numbers 1–3 below.
Mode 1: static warm light
Mode 2: static natural white light
Mode 3: static cool white light
Mode 4: static red light
Mode 5: static green light
Mode 6: static blue light
Mode 7: RGB fade in/out
Mode 8 : RGB flash
Mode 9: selected color breathing (selected color cycles from 100% to 0% and back repeatedly)