SMART CHOICE 5304490733 4 Feet Gas Range Connector Installation Guide
- June 3, 2024
- SMART CHOICE
Table of Contents
SMART CHOICE 5304490733 4 Feet Gas Range Connector
⅝” OD x 4′ Gas Range Connector
5304490733
Connecteur pour cuisinière au gaz de ⅝ po de diamètre extérieur x 1,2 m (4 pi)
Conector de horno de gas de ⅝ in de diámetro exterior x 4 ft
Installation
-
Clean the pipe threads, and then apply pipe thread sealant to the male pipe threads. Do NOT use sealant on flare fitting ends as this will prevent a good seal.
-
Form the connector into installation shape avoiding sharp or repeated bending.
-
Wrench-tighten the brass Safety+PLUS valve fitting to the manual shut-off valve and the steel flare union fitting to appliance pressure regulator. Use a second wrench to stabilize the shut-off valve and regulator during tightening.
WARNING
Do NOT connect the Safety+PLUS valve fitting directly to the appliance pressure regulator. If installed at the appliance regulator, the Safety+ PLUS valve fitting will NOT operate properly and will NOT respond to excess gas flow. -
Wrench-tighten the captive connector nuts to the Safety+PLUS valve fitting and steel fitting. Use a second wrench to stabilize the shut-off valve.
WARNING
DO NOT TURN ON THE APPLIANCE UNTIL ALL CONNECTIONS ARE LEAK TESTED! DO NOT use a flame or another source of ignition to test for leaks. -
Turn on the gas supply and test all connections for leaks with the included leak detector solution. Bubbles indicate a leak. If a leak is present, turn off the gas and tighten the connection further, then test the connections for leaks again.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>