inVid Tech 1 to 4 HDMI Extender Splitter User Manual

inVid Tech 1 to 4 HDMI Extender Splitter

Important Safety Notes

1. Do not plug-in/out the network cables and IR cables when it is in using.
2. Use DCSV only. Make sure the specification matched if using 3rd party DC adapters.

Introduction
This product combines the extender and splitter function to split 1 HDMI signal to 4 identical HDMI signals via network cable and it is used as a sender to work with 4 receivers to transmit these 4 HDMI signals up to 120meters.
With the IR signal transmission to control the source device operation
in long distance, it is widely applied in HD audio visual display room, HDTV, Set top box, DVD etc exhibition center and digital monitoring system.

Features

1. Adopting a new high-definition digital transmission technology, lower delay and more stable performance.
2. lt splits one HDMI input signal to four identical network output signals.
3. Extend HDMI signal up to 120m over CATS/Se/6 cable.
4. Support full HD resolution 1080p@60Hz.
5. Support cascade connection by switch or router.
6. Compatible with existing network ,not affect internet.
7. Plug and play,use easily.
8. Convenient wall-mountable design.

Installation Requirement

1. HDMI source device(computer graphics card, DVD,PS3, HD monitoring equipment etc)
2. HDMI display device like SDTV, HDTV, and projector with HDMI port.
3. HDMI extender RX
4. UTP/STP catS/Se/6 cable, follow standard IEEE-568B Network cable length supported between every connection:
   • CATS 80m
   • CATSE 100m
   • CAT6120m

Package contents

Panel description

Connection and operation

Network cable
Follow the standard of IEEE-568B:

1. Orange/white
2. Orange
3. Green/white
4. Blue
5. Blue/white
6. Green
7. Brown/white
8. Brown

Connection:

Connection instruction:

1. Connect HDMI input with HDMI output of source device.
2. Connect IR blaster extension cable to the IR extender out port.
3. Connect RJ45 port with RJ45 input port of HDMI extender RX.
4. Connect HDMI output of HDMI extender RX to HDMI input of HDTV and set the TV source input to correct HDMI input channel.
5. Power on the device (power indicator led lights) and it works.

FAQ

• Q: TV display “waiting for connection” on the bottom right corner?
  A:

1. Please check if the power supply of the unit (sender) and RX(receiver) is well connected and the power indicator led lights on.
2. Make sure all cables are firmly connected.

• Q: TV display “Please check the TX input signal” ?
  A:

1. please check if there is An HDMI signal input of the unit
2. Try to connect the signal source directly to display device to see if there is signal output from source device or change the signal source, HDMI cables and try again.

• Q: Display not fluent and stable?
  A:

1. Please check the cable length between the unit(sender) and RX (receiver) is within the required range.
2. Press “reset” button on the unit/RX panel, reset and reconnect.

Specification

Disclaimer

The product name and brand name may be registered trademark of related manufactures.'” and® may be omitted on the user manual.
The pictures in this user manual are just for reference. The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc. We reserve the rights to make changes without further notice to a product or system described herein to improve reliability, function or design.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>