hygger HG045 Aquarium Heater User Manual
- June 3, 2024
- hygger
Table of Contents
hygger HG045 Aquarium Heater User Manual
hygger tiny titan is a perfect aquarium heater for 1~20 gallon aquariums and is best for desktop, office, or home use.
CAUTION
- Place the hygger heater fully submersible when it’s on, unplug it and wait for 15 minutes before changing the water or removing the heater.
- Please ensure enough water flow and water circulation in the fish tank when using the heater.
PRODUCT FEATURES
LED digital temperature display: Multi-function LED digital display shows the current water temperature and sets the temperature clearly and accurately.
External temperature controller and easy use: In one clip, set the desired temperature and check the setup record. You can set up the temperature when it flashes. After the setting is completed, the numbers are stable and no longer flashing. Press the “SET’ button can check your setup record in one clip.
Memory Function and shut-off automatically: The memory function can maintain the setting when the power is back on. It will stop heating after reaching the set ternperature.
Explosion-proof quartz heating tube: Explosion-proof and insulation the quartz tube is safer than traditional coil heaters.
Intelligent temperature safety control protects against running dry: Shut off automatically when the heater is exposed to air, and the LED display flash “Er” and the current temperature. When the temp reach or pass 95°F(35°C), the LED display shows “EE”, and then the heater will shut off automatically.
Small size is ideal for small aquarium tanks
Suitable for freshwater and saltwater
PRODUCT SPECIFICATIONS
Model | HG045 |
---|---|
Power | 15W |
Application | 1-2.5Gal (3.5~9.5L) |
10-20Gal (38~75L)
Volt./Freq:| US standard: AC 110-120V/60Hz UK/EU standard:
AC220-240V/50Hz
Cord length| 0.8m+1.2m(2.6ft+3.9ft)
Temp accuracy| ±1°F(±1 °C )
Control range| 59°F~93°F(15°C~34°C)
Heating rod dimension| 4.3″x1.9″x0.9″(11cm x 4.8cmx2.4cm)
INSTRUCTIONS
a) The digital started flashing for 3 seconds when it was plugged in. Then it
can be adjusted to the desired temperature. The indicator light turns red, and
the heater is on.
b) It will turn green when the heater reaches the set temperature, which means
the heating rod is not It will start heating when the temperature is lower
than 1°F.
For example, your desired temperature is 90°F. Just press the “SET” button
until “90” is shown on the display screen and wait for the digit “90” to flash
three times; then, it will show the current water temperature. Your setting is
done.
The “SET” button can check the previous setup record in one clip.
APPLICATION
Place the heater as follow diagram:
MAINTENANCE
- Unplug or switch off all appliances in the aquarium before carrying out maintenance.
- Do not use detergents or other chemical cleaners.
- To clean the heater, unplug it first and then leave the heater in the tank for 15 minutes and remove it from the tank. Wash the heater in clean water.
Here is the correct instruction for the cleaning as per the following steps:
a) Hands hold the heater, push down the clip on the back first, and then open
the cover.
b) Use the brush to clean the heater when opening the cover.
C) Important reminder :
The two slots at the end of the heating rod are aligned with the groove first
and then pressed down to close the cover well.
Step 1: aligned with the groove first.
Step 2: push down to close the cover well.
- When reinstalling the heater, select your desired location and position the heater below the water.
- This appliance has no parts that users can repair.
- For indoor use only, not in the bathroom.
TROUBLESHOOTING
Fault | Explanation | Solutions |
---|---|---|
Er | Out of water shutoff | Fully submersible into the water |
EE flash | Over 95°F temperature | Fill into the cool water or wait for 1 °F |
lower temperature and the EE flash will be cancelled
Heater turns red indication when it’s out of the water| Failed the out of
water shutoff function| Clean the heater cover, and see if it turns green
indication when out of the water
Heater is working but can not reach the setup temperature| ambient temperature
is below 50°F(10°C) or the setting temperature differs from the ambient
temperature by 50°F(10°C)| Choose the more large heater or use one more heater
H1| Probe is broken| Unplug the power immediately, prohibit use anymore, and
replace new heater.
H2
E1
E2
E8
EL
| Reminder after 10,000 hours of use| Reminder can not be cleared, to be safe, it is recommended to repurchase
WARNING
To avoid possible electric shock, do not immerse the switch in the water. If the switch falls into the water or becomes wet, do not touch it until you have unplugged it. Basic safety precautions that should be observed are as follows:
-
Read and follow this user manual strictly.
-
DANGER- To avoid possible electric shock, special care should be taken since water is employed in the use of aquarium equipment. For each of the following situations, do not attempt to repair yourself. Instead, return the heater to an authorized service facility for maintenance or discard it.
A. If the heater show any sign of abnormal working or, unplug the power and remove the heater from the water after 15 minutes.
B. Carefully examine the heater after It should not be plugged in if there is water on parts that are not intended to be wet.
C. Do not operate the heater if it has a damaged cord or plug, is malfunctioning, dropped, or damaged in any The power cord of this heater cannot be replaced. If the cord is damaged, the heater should be discarded.
D. To avoid the possibility of the heater plug getting wet, position the aquarium and its stand to one side of a wall mounted outlet to prevent water from dripping onto the outlet or A “drip loop”, shown in the figure below, should be arranged by the user for each cord, which connects the heater to the outlet If an extension cord is used, the “drip loop” is the part of the cord below the level of the outlet or the connector that prevents water from traveling along the cord and coming in contact with the outlet If the plug or outlet does get wet, DO NOT unplug the cord. Disconnect the fuse to the circuit breaker that supplies power to the heater. Then, unplug and examine for the presence of water in the outlet If you are not sure, consult a certified electrician. -
Close supervision is necessary when the heater is used near children.
-
This heater is not allowed to use by persons (including children) with reduced physical sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the heater by a person responsible for their safety.
-
To avoid injury, do not contact moving or hot parts.
-
Always unplug the heater from the outlet when not in use, before putting on or taking off parts, maintenance, or placing hands in the water. Never yank the cord to pull the plug from the outlet Grasp the plug and pull to disconnect.
-
Do not use the heater for other than intended use. The use of attachments not recommended or sold by the appliance manufacturer may cause an unsafe condition and will void the warranty.
-
Do not install or store the heater where it will be exposed to extreme weather or temperatures below freezing.
-
Only use the heater in freshwater or saltwater, do not use it in other liquids.
-
Make sure the heater is securely installed before operating it.
-
Read and observe all the important notices on the heater.
-
If an extension cord is necessary, a cord with a proper rating should be used, such as rated amperes or watts. A cord rated for fewer amperes or watts than the heater rating may overheat. Care should be taken to arrange the cord so that it will not be tripped over or pulled.
-
The 2-conductor power cord has a polarized plug (one blade is wider than the other.) As a safety feature, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never use it with an extension cord unless the plug can be fully inserted. Do not attempt to defeat this safety feature.
-
The heater is intended FOR HOUSEHOLD USE ONLY.
-
SAVE THIS USER MANUAL
ATTENTIONS
- Please check all the items to inspect their condition when unboxing the package.
- Please read this user manual carefully before using it and follow it strictly.
- Please choose a heater rated for your aquarium.
- Please place the heating rod in the way of water flow and don’t bury it in the substrate.
- It is suggested that the heater is submerged more than 5 inches below the water.
- Please make sure the heating rod is fully submerged when it’s on duty. Unplug the heater and wait for 15 minutes before changing the water or removing the heater.
- Please mind that the heater can be turned off automatically when exposed to air, but it is a I ast resort and should be avoided.
- After using the heater for a while, calcium carbonate contained in algae or moss may clump and adhere to the heating rod.
- If dirt adheres to the heating rod, use a sponge or cloth and water to wipe it. Do not use alcohol or other chemicals as this may damage the heater and harm the fish or other livestock.
- If you use the heater for a prolonged period with dirt adhered to the heating element, please be aware that failure may occur due to the inability to control the temperature correctly.
- Please place the heating rod far away from the magnetic brush since the magnet will possibly damage the heating element.
- There will be a little mist on the inner wall of the tube while heating, and it will disappear slowly after the heating stops, which means it’s a normal phenomenon. So you don’t have to worry about it, it is a safe and double-protected product that has passed the UL certification.
ONE YEAR LIMITED WARRANTY
This product MUST be purchased from an authorized hygger reseller. Visit our website for a list of authorized resellers. Hygger warrants this product against defects in materials and workmanship for ONE(1) YEAR from the date of the original retail purchase and is non-transferable.
Warranty on all products, including aquariums. But it is limited to the replacement of the products and does not cover fish loss, personal injury, property loss or direct, incidental or consequential damage caused by using this product.
Note: Hygger One-year Limited Warranty does not cover damage caused by the followings: improper installation, saltwater corrosion, electrical surges or modifications.
If you discover a defect, please contact hygger, who will, at its option, repair or replace the product at no charge, provided that you return it during the warranty period. A copy of the bill of sale is required as proof of the original purchase date in the event of the product needing repairs within the warranty period. Hygger does not warrant any products that are not hygger’s.
This warranty does not apply if the product has been damaged by accident, abuse, misuse or misapplication, or modified without the written permission of hygger.
DISPOSAL
Do not dispose of this product as unsorted municipal waste. Collection of such waste separately for special treatment is necessary. This product has to be disposed of at an authorized place for the recycling of electrical and electronic appliances rather than being disposed of together with the domestic waste. Collecting and recycling waste is a way of saving natural resources. So, please consult with your local seller to make sure the product is disposed of in an environmentally friendly way.
PACKING LIST
- 1x heater rod with an external controller
- 1x user manual
CONTACT INFORMATION
Company name: Shenzhen Mago Trading Co., Ltd
Add: Bantian Group Business Central, Longgang District, Shenzhen City,
Guangdong Province, China
Website: www.hygger-online.com
E-mail: Mago@hygger-online.com
If you have any problems, please provide your amazon order id (amazon
invoice) and shipping address by E-mail: mago@hygger-
online.com.
Company:E-CrossStu GmbH
Address: Mainzer Landst r.69,60329 Frankfurt am Main
E-maiI: e-crossstu@outlook.com
Tel: +49 69332967674
CET Product Service Ltd.
Beacon House Stokenchurch Business Park,lbstone Rd,Stokenchurch High Wycombe
HP14 3FE UK info.cetservice@gmail.com
+447419325266
MADE IN CHINA
Documents / Resources
|
hygger HG045 Aquarium
Heater
[pdf] User Manual
HG045 Aquarium Heater, HG045, Aquarium Heater, Heater
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>