BaLDR B0359WST4H4PR Wireless Color Weather Station with 3 Remote Sensors User Guide
- June 4, 2024
- BALDR
Table of Contents
B0359WST4H4PR Wireless Color Weather Station with 3 Remote Sensors
User Guide
MODEL: B0359WST4H4PR
WIRELESS COLOR WEATHER STATION WITH 3 REMOTE SENSORS
POWER ON
Main Unit Installation
Step1, Peel off the protecting mask of the main unit.
Step 2 , Plug the AC Adaptor to a powered outlet.
Step 3, Remove the built-in cell battery insulation strip.
Sensor Installation
Step 1, Select the channel on each sensor
Step 2, Load the 2xAA batteries to each sensor within 3 minutes to ensure the RF signal is received in time.
NOTE:
If not powered on within 3 minutes from the main unit powered on.
Press and hold the “CH” button for 3 seconds to search the RF signal again.
MAIN UNIT SETUP
After Power On
LCD will fully display for 3
seconds with a “BI” sound.
After 3 seconds, the LCD will display the data below
RF Signal Searching
The receiving antenna signal will flash
RF Signal Received
Automatically display, and the antenna signal will stop flashing.
RCC Radio Signal Receiving Automatically
RCC Radio Signal Searching for 7 Minutes
The antenna symbol is flashing.
The backlight brightness will go dim to 3% and no buttons except ▲/RCC will
function.
Press & hold the ▲/RCC button will allow exiting the Atomic mode to continue manual setup.
No RCC Radio Signal Received
Press and hold “▲/RCC ” button for 3 seconds to search RCC radio signal
again
Manual setup
- Press and hold “SET” button to enter into setup (3 seconds).
- Press and release “SET” button to skip setting or go to next setting option(1 second).
SETUP ORDER
|
---|---
*Tips: press and hold “▲/RCC” or “ ▼ ” button will quickly change the value.
This Qucik Start is to help you quickly set up the product. For detailed
settings, please refer to the user manual, or scan the QR code below for
relevant product information and operation video link.Thank you.
http://www.baldr.com/
www.baldr.com
[email protected]
:1-833-381-5659