SSB AIRCELL 7, ECOFLEX 7 BNC-Connector Instruction Manual
- June 3, 2024
- SSB
Table of Contents
SSB AIRCELL 7, ECOFLEX 7 BNC-Connector Instruction Manual
Required tools :
1 x cutter knife
1 x Scissors
1 x soldering station
1 x open-ended spanner 12 mm
1 x open-ended spanner 13 mm
Cut off cable tail right-angled.
Move the nut, clamping ring and rubber washer over the cable tail.
Remove 7 mm of the outer jacket with a knife. Then slide the spacer ring onto the copper mesh.
Bend up the copper mesh at a right angle. Insert the contact sleeve between the copper foil and the braid as far as it will go. Cut off the protruding braid. Push the rubber seal forward up to the contact sleeve.
Use a knife to remove the copper foil and dielectric.
Slide the Teflon disc over the inner conductor. Then attach the inner pin and through the small hole carefully solder
Push the prepared cable end into the connector housing as far as it will go. Hand-tighten the clamping nut with two open-end wrenches 12 mm and 13 mm. A small gap between nut and connector housing should still be visible!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>