sygonix 2574833 Battery Operated Star Light Chain Instruction Manual
- June 3, 2024
- Sygonix
Table of Contents
sygonix 2574833 Battery Operated Star Light Chain
Intended use
The product is a decorative light. The product is not suitable for domestic lighting. The product has an IP44 ingress protection rating. It is splash proof and suitable for outdoor use. Do not submerge in water. If you use the product for purposes other than those described, the product may be damaged. Improper use can result in short circuits, fires, or other hazards. The product complies with the statutory national and European requirements. For safety and approval purposes, you must not rebuild and/or modify the product. Read the operating instructions carefully and store them in a safe place. Make this product available to third parties only together with the operating instructions. All company names and product names are trademarks of their respective owners. All rights reserved.
Delivery contents
- Product
- Operating instructions
Latest product information
Download the latest product information at
www.conrad.com/downloads or scan the QR
code shown. Follow the instructions on the website.
Description of symbols
The following symbols are on the product/appliance or are used in the text:
- The symbol warns of hazards that can lead to personal injury.
- Read the operating instructions carefully.
- This product is constructed according to protection class III
Safety instructions
Read the operating instructions carefully and especially observe the safety information. If you do not follow the safety instructions and information on proper handling, we assume no liability for any resulting personal injury or damage to property. Such cases will invalidate the warranty/guarantee.
General
- The product is not a toy. Keep it out of the reach of children and pets.
- Do not leave packaging material lying around carelessly. This may become dangerous playing material for children.
- If you have questions that remain unanswered by this information product, contact our technical support service or other technical personnel.
- Maintenance, modifications and repairs must only be completed by a technician or an authorised repair centre.
Handling
- Handle the product carefully. Jolts, impacts or a fall even from a low height can damage the product.
Operating environment
- Do not place the product under any mechanical stress.
- Protect the appliance from extreme temperatures, strong jolts, flammable gases, steam and solvents.
- Protect the product from direct sunlight.
Operation
- Lights become hot. Risk of fire! Remove from packaging before operating. Fully lay lights out and install before operating.
- Consult an expert when in doubt about the operation, safety or connection of the product.
- If it is no longer possible to operate the product safely, take it out of operation and protect it from any accidental use. DO NOT attempt to repair the product yourself. Safe operation can no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
(Rechargeable) Batteries
- Correct polarity must be observed while inserting (rechargeable) batteries.
- The (rechargeable) batteries should be removed from the device if it is not used for a long period of time to avoid damage through leaking. Leaking or damaged (rechargeable) batteries might cause acid burns when in contact with skin, therefore use suitable protective gloves to handle corrupted (rechargeable) batteries.
- (Rechargeable) batteries must be kept out of reach of children. Do not leave (rechargeable) batteries lying around, as there is risk, that children or pets swallow them.
- All (rechargeable) batteries should be replaced at the same time. Mixing old and new (rechargeable) batteries in the device can lead to (rechargeable) battery leakage and device damage.
- (Rechargeable) batteries must not be dismantled, short-circuited or thrown into fire. Never recharge non-rechargeable batteries. There is a risk of explosion!
LED light
- Do not look directly into the LED light!
- Do not look into the beam directly or with optical instruments!
Installing batteries
Note: If an insulating strip protrudes from the battery compartment, batteries are installed already. Pull the strip out to establish the power supply.
Preconditions:
Prepare the required number of batteries of the correct type as stated in the
section “Technical data”.
- Unlock the battery compartment cover and open the battery compartment.
- Insert the batteries into the battery compartment observing the polarity markings in the compartment.
- Close and lock the battery compartment cover.
Operating the lights
Push the power button on the battery compartment to activate different operating modes and to switch the lights off.
- Press the power button to switch modes according to the following sequence: TIMER → ON → OFF.
Cleaning and care
Important:
- Do not use aggressive cleaning agents, rubbing alcohol or other chemical solutions. They damage the housing and can cause the product to malfunction.
- Do not immerse the product in water.
Disposal
Product
This symbol must appear on any electrical and electronic equipment placed
on the EU market. This symbol indicates that this device should not be
disposed of as unsorted municipal waste at the end of its service life. Owners
of WEEE (Waste from Electrical and Electronic Equipment) shall dispose of it
separately from unsorted municipal waste. Spent batteries and accumulators,
which are not enclosed by the WEEE, as well as lamps that can be removed from
the WEEE in a non-destructive manner, must be removed by end users from the
WEEE in a non-destructive manner before it is handed over to a collection
point.
Distributors of electrical and electronic equipment are legally obliged to
provide free takeback of waste. Conrad provides the following return options
free of charge (more details on our website):
- in our Conrad offices
- at the Conrad collection points
- at the collection points of public waste management authorities or the collection points set up by manufacturers or distributors within the meaning of the ElektroG
(Rechargeable) batteries
Remove batteries/rechargeable batteries, if any, and dispose of them
separately from the product. According to the Battery Directive, end users are
legally obliged to return all spent batteries/rechargeable batteries; they
must not be disposed of in normal household waste.
Batteries/rechargeable batteries containing hazardous substances are labelled
with this symbol to indicate that disposal in household waste is forbidden.
The abbreviations for heavy metals in batteries are: Cd = Cadmium, Hg =
Mercury, Pb = Lead (name on (rechargeable) batteries, e.g. below the trash
icon on the left).
Used (rechargeable) batteries can be returned to collection points in your municipality, our stores or wherever (rechargeable) batteries are sold. You thus fulfil your statutory obligations and contribute to environmental protection. Batteries/rechargeable batteries that are disposed of should be protected against short circuit and their exposed terminals should be covered completely with insulating tape before disposal. Even empty batteries/rechargeable batteries can contain residual energy that may cause them to swell, burst, catch fire or explode in the event of a short circuit.
Technical data
Power supply
- Battery power supply ………………… 4.5 V, 3 x 1.5 V, type AA battery
Light
- Illuminant ………………………………… LED
- Replaceable illuminant ……………… No
- LED count ………………………………… 10
- Colour temperature …………………… 3000 – 3200 K
Environment
- Operating temperature ……………… -20 to +40 °C
- Storage temperature …………………. -20 to +50 °C
Others
- Ingress protection …………………….. IP44
- Lead wire length ……………………….. 34 cm
- Dimensions (W x H x D) (approx.) . 40 x 40 x 34 cm
- Weight (approx.) ………………………. 150 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or the capture in electronic data processing systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited. This publication reflects the technical status at the time of printing.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>