resideo WLD3CABLE Cable Sensor for WiFi Water Leak and Freeze Detector Instruction Manual
- June 3, 2024
- resideo
Table of Contents
resideo WLD3CABLE Cable Sensor for WiFi Water Leak and Freeze Detector
Instruction Manual
INSTALLATION INSTRUCTIONS
APPLICATION
The optional WLD3CABLE sensor for the WiFi Water Leak and Freeze Detector
extend the sensing range of
the detector. Multiple cable sensors can be connected to each other, up to 500
feet in length.
INSTALLATION
Installing Additional Cable Sensors
-
Insert the plug from the accessory cable sensor into the jack on the water leak detector, as shown in Fig. 1.
Fig. 1. Plugging in additional cable sensors.
-
For additional cable sensors, plug each new accessory sensor into the end of the previous accessory sensor, then plug in the original cable sensor at the end of the cable.
The detector and cable sensors are all reusable.
After an alarm, simply wipe dry the detector and cable sensors and put them
back in place.
For detector and cable sensor operation, refer to the Resideo app and the
literature that came with the detector.
Customer Support
© 2022 Resideo Technologies, Inc. All rights reserved.
This product is manufactured by Resideo Technologies, Inc. and its affiliates.
Resideo Technologies, Inc.
1985 Douglas Drive North, Golden Valley, MN 55422
1-800-633-3991
33-00627EFS 01 M.S. Rev. 08-22 | Printed in United States
Web: www.resideo.com
Phone: 1-800-633-3991
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>