SNAPTAIN SP7100 Foldable GPS Drone User Guide
- June 3, 2024
- SNAPTAIN
Table of Contents
- SNAPTAIN SP7100 Foldable GPS Drone
- PACKING LIST
- PRODUCT OVERVIEW
- GET STARTED
- Prepare the Drone
- Prepare the Remote
- Pair the Remote with the Drone
- Calibrate the Compass
- Calibrate the Gyro
- Search GPS Satellites
- Launch Captain Epic App
- Take-off
- Flight Directions
- Landing
- PARAMETERS
- IMPORTANT NOTE
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
SNAPTAIN SP7100 Foldable GPS Drone
PACKING LIST
PRODUCT OVERVIEW
Notes:
- Remove the protective film from the camera.
- Please do not manually adjust the camera to avoid damage to it.
Remote
- Antenna
- Headless Mode (short press) Emergency Stop (long press) Modo Headless
- Left Control Stick
- Smart RTH (Return-to-Home)
- RTH Inteligente (Return-to-Home)
- Handle
- Mango
- Phone Clamp
- Remote Power Indicator
- Headless Mode Indicator
- Indicador de Modo Headless
- RTH Indicator
- Indicator RTH
- GPS Mode Indicator
- Indicador del Modo GPS
- GPS Mode On/Off (long press)
- Modo GPS On/Off
- Right Control Stick
- One Key lake-off/Landing
- ON/OFF
- Encendido
- Charging Port
- Speed Switch
- Camera Tilt
- Photo
- Video
GET STARTED
- Please fly the drone outdoors where GPS signal is strong.
Prepare the Drone
- Support up to 64GB.
- The memory card of FAT32/ exFAT format is required.
- Soporte hasta 64GB.
Prepare the Remote
Pair the Remote with the Drone
- Turn on the drone. Place it on a flat surface with the head forward.
- Turn on the remote.
- Wait for the remote to automatically pair with the drone. Pairing is complete when the remote beeps once, and the four indicators on it turn solid on.
Calibrate the Compass
- The drone has been prepared for compass calibration after pairing.
- Hold the drone horizontally and make full rotation at least twice until the remote beeps once, which indicates a successful horizontal calibration.
- Hold the drone vertically with its head tacing up, and make a full rotation at least twice until the remote beeps once, which indicates a successful vertical calibration.
Calibrate the Gyro
- Place the drone on a flat surface after finishing compass calibration. Calibration is complete when the remote beeps once.
Search GPS Satellites
- Wait for the drone to search satellites. When you hear a long beep from the remote and its GPS Mode Indicator starts flashing, the drone has found enough satellites and is ready to take off in GPS Mode.
Launch Captain Epic App
- Download on the App Store”/Google Play or scan the QR code below.
Note
Google Play is a trademark of G0ogle Inc., and App Store is a trademark of
Apple Inc.
Take-off
- The drone is set to GPS Mode by detault. It cannot take oft it GPS mode is unavailable. Please fly the drone outdoors where GPS signal is strong.
- Switch to ATTI Mode (refer to user manual) if you would like to fly the drone indoors where GPS mode is unavailable.
Flight Directions
Landing
PARAMETERS
FCC Caution
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. This
device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
IMPORTANT NOTE
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur ina particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult thee dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.This equipment should be installed and operated with
minimum distance 20cm environment. (aircraft)
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.( remote control)
- Tutorial Video/Videotutorial
CAPTAIN SUPPORT
- www.snaptain.com
- @snaptainofticial
- @snaptain_official
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>