HESSAIRE MC26A 2100 CFM Mobile Evaporative Cooler User Guide

Mobile Evaporative Cooler
2100 CFM
Use & Care Guide
MC26A
MC26 Online Manual Eng Spa 081621

General Safety Precautions

** Read and follow all instructions, cautions and warnings. Failure to do so could result in personal injury, death or property damage.
Unit must be in OFF position and UNPLUGGED from power receptacle before performing any maintenance / service or before REMOVING access panels.
Make sure the electrical power source conforms to the requirement of the evaporative cooler as well as local codes. To reduce risk of fire or electrical shock, do not expose electrical connections to water. Do not touch electrically live components.
Ensure all power cords do not touch sharp edges, hot surfaces or chemicals.
Immediately replace damaged parts. Never leave unit unattended. Continuous fill not to be used indoors or unattended.
Operation Tips
Hessaire coolers are highly recommended for outdoor use.
If used indoors, position cooler in front of window or open door for fresh intake air. Ensure there is an open door or window through which the air can exhaust from the room. Clean media pads and tank frequently. When shutting down unit, run without pump for 30 minutes to properly dry media pads.
Prior to long term storage: Drain tank and wipe clean Dry and clean rigid media pads
Indoor Use:** Do Not Use Garden Hose Attachment.

Inspection

After unpacking your cooler, carefully inspect for any damage that may have occurred during transit. Inspect for loose, missing or damaged parts. Note: wheels & hardware are located in ice door compartment on top of cooler.
Contents: Evaporative Cooler (1), Hose Adapter (1), Caster Wheels (4), Ice Packs (2), Remote Control (1). Visit Hessaire.com to request replacement parts if any of these items are missing.
Quick Start

Note: Media pads may have a slight odor upon initial start up but will go away with continued use.

MC26 Online Manual Eng Spa 081621

Features

Control Panel For MC26A: With Humidity Control

Swing Button: Press to operate oscillation feature.
Timer Button(light on when engaged): Press to select desired run time. All features will stop running when time expires.
Pump Button: Pump functions continuously when light is on.
Set humidity level by pressing and holding the pump button for 2 seconds. The setting range is 50% to 90% RH. Each press of the button will increase RH by 5%. Once the desired RH is adjusted, the value will flash for 5 seconds.
The setting is automatically activated after 5 seconds.
Fan Button: Controls 3 different fan speeds
Power Button: Green light on allows all functions to operate.
When the red light is on, functions will not be operable.

Maintenance

WARNING Disconnect from power source before attempting any maintenance or routine service. NEVER remove any access panels while cooler is in operation.
Failure to do so could lead to SERIOUS INJURY.
Cleaning Cooler & Rigid Media Pads:
The removable panel(s) & pads can be gently sprayed off to remove build up. A soft bristle brush can also be used.
NEVER spray pads with water while cooler is in operation.
Damage can occur to the motor and will void the warranty.
Note: Vinegar is recommended for cleaning of cooler and can be periodically cycled through during normal use.
Removal Of Back Panel: Disconnect power supply. Remove the two phillips screws from the upper back side of cooler.
Push panel up and pull bottom out to remove.

Removal Of Rigid Media: Once back is removed, the media pads will be accessible.
Note: some pads may be held in place with pins (media keepers) which will need to be removed to free up the pads. Storage: Drain tank and wipe dry. Plug is located on bottom of cooler. Ensure pads are dry by running fan without pump for at least 30 minutes.
Visit Hessaire.com for additional maintenance tips and service videos.

Troubleshooting

Receptacle breaker may need to be reset.
If unit is equipped with a GFCI plug, reset.
If unit has a timer, ensure it is off.
May need new ON/OFF switch.
Fan will not operate| Ensure fan function is on.
Make sure nothing is obstructing fan blade.
Fan motor may need to be replaced.
Fan switch may need to be replaced.
Slow running – may need capacitor replaced.
Cooler does not pump| Ensure pump switch is turned on.
Make sure water level is not low. Add water.
Make sure hoses are connected and free of debris.
Pump may need to be replaced.
Pump switch may need to be replaced.
Swing does not work| Ensure swing switch is turned on.
Make sure the linkage is connected.
Oscillation switch may need to be replaced.
Oscillation motor may need to be replaced.
Water leakage| Make sure drain plug is securely in place.
Make sure cooler is level.
Inspect tank for cracks.
Check media pads for water running on outside of unit.
Change pads if necessary.
Check for leaks in water distribution hose connections.
Check spreaders for build up causing spill over of
water into the airstream.
Water level high or low| Adjust nut on float valve.
Float valve may need to be replaced.

Cooler Parts

Hessaire Warranty

Each new cooler is warrantied to be free from defects in material or workmanship for one full year from the date of original purchase. If a component(s) is found to be defective within this period, the defective part will be provided free of charge. Replacement parts are available through authorized dealers or online. Copy of proof of purchase and serial label will be needed for all warranty claims.
What is not covered: Malfunctions resulting from misuse, negligence, alteration or lack of necessary maintenance. Loss of time, inconvenience, use of product or other consequential damages due to defects. Return transportation costs. All return costs are the responsibility of the purchaser. Hessaire does not cover labor costs associated with troubleshooting or cooler repairs regardless if the product is under warranty or not.
Damaged Shipments: Hessaire is not responsible for damaged shipments or shortages resulting from carrier mishandling. Notify your carrier’s office immediately to file a freight claim in the event of damage. Keep damaged product for inspection until advised by carrier as to disposal.
Please DO NOT return your cooler to Hessaire. Upon authorization, any returns should be sent directly to the distributor/store where purchased.
Instructional videos and other helpful parts replacement information is available on hessaire.com.
Visit hessaire.com for registration & warranty claim forms.

References

• Hessaire.com - Cool Air Anywhere!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>