NETGEAR MK82 Tri-Band Mesh Wi-Fi 6 Add-On Satellite User Guide
- June 5, 2024
- NETGEAR
Table of Contents
Quick Start
-
Download the Nighthawk app to install your mesh system on your mobile phone, download the Nighthawk app and follow the setup instructions.
-
Secure your devices with NETGEAR Armor
Tap the Security icon in your Nighthawk app to verify that NETGEAR Armor™ is activated.
Your Nighthawk comes with NETGEAR Armor cybersecurity. Armor blocks online threats like hackers and phishing attempts on your devices. -
Do more with the app
Check out everything you can do on the Nighthawk app! Run a speed test, pause the Internet, see all the connected devices, and more.
Contents
Overview
1 LED
A Sync button
B Reset button
C Ethernet ports
D Internet port
E Power connector
Troubleshooting
If you’re having problems with the installation, try one of the following:
-
Turn off your modem and router and disconnect them.
Restart your modem. Reconnect your router to your modem, and try installing with the Nighthawk app again. -
If you’re still unable to install your router using the Nighthawk app, manually install it using the router web interface.
Visit http://www.routerlogin.net to access the router web interface.
For more information, visit netgear.com/meshhelp.
Support and Community
Visit netgear.com/support to get your questions
answered and access the latest downloads.
You can also check out our NETGEAR Community for helpful advice at
community.netgear.com.
Regulatory and Legal
(If this product is sold in Canada, you can access this document in Canadian
French at https://www.netgear.com/support/download/.)
For regulatory compliance information including the EU
Declaration of Conformity, visit https://www.netgear.com/about/regulatory/.
See the regulatory compliance document before connecting the power supply.
For NETGEAR’s Privacy Policy, visit https://www.netgear.com/about/privacy-
policy.
By using this device, you are agreeing to NETGEAR’s Terms and Conditions at
https://www.netgear.com/about/terms-andconditions.
If you do not agree, return the device to your place of purchase within your
return period.
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
– Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
It is restricted to the indoor environment. This device meets all the other
requirements specified in Part 15E, Section 15.407 of the FCC Rules.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 27cm between the radiator & your body.
NETGEAR, Inc.
350 East Plumeria Drive
San Jose, CA 95134, USA
© NETGEAR, Inc., NETGEAR, and the NETGEAR Logo are trademarks of NETGEAR, Inc.
Any non‑NETGEAR trademarks are used for reference purposes only. July 2020
NETGEAR INTERNATIONAL LTD
Floor 1, Building 3,
University Technology Centre
Curraheen Road, Cork,
T12EF21, Ireland
References
- English - NETGEAR Communities
- NETGEAR Support | NETGEAR
- Download Center | Downloads and Documentation | NETGEAR
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>