FUJIFILM FAN-001 Cooling Fan Instruction Manual

: June 3, 2024
: Fujifilm

Table of Contents

FUJIFILM FAN-001 Cooling Fan
FCC Statement
EC Declaration of Conformity
WARNINGS AND CAUTIONS
Product Care
SPECIFICATIONS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

FUJIFILM FAN-001 Cooling Fan

FUJIFILM-FAN-001-Cooling-Fan-PRODUCT

Thank you for purchasing this Fujifi lm product, a camera cooling fan that can be mounted on the camera to provide air cooling. For inspection, maintenance, and repair, consult the original retailer or bring the unit to a Fujifi lm service center.

For a list of compatible cameras, visit: https://fujifilm-x.com/support/compatibility/accessories/
When using this product, refer both to this guide and to the section on cooling fans in the camera Owner’s Manual available from the website below.
https://fujifilm-x.com/support/manual/cameras/

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However it is not guaranteed that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to avoid the interference by one or more of the following measures ;

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from the one to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

You are cautioned that any changes or modifications not expressly approved in this manual could void your warranty.

For Customers in Canada

CAUTION:
CANICES-3(B)/NMB-3(B)
This Class B digital apparalus meets all requirements of the Canadian interference-Causing Equipment Regulations.

Disposal of Electrical and Electronic Equipment in Private Households

In the European Union, Norway, Iceland and Liechtenstein: This symbol on the product, or in the manual and in the warranty, and/or on its packaging indicates that this product shall not be treated as household waste. Instead it should be taken to an applicable collection point for the recycling of electrical and electronic equipment.

By ensuring this product is disposed of correctly, you will help prevent potential negative consequences to the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.

EC Declaration of Conformity

We
Name: FUJIFILM Europe GmbH
Address: Heesenstrasse 31, 40549 Dusseldorf, Germany declare that the product
Manufacturer’s Name: FUJIFILM Corporation
Manufacturer’s Address: 7-3, AKASAKA 9-CHOME, MINATO-KU, TOKYO, 107-0052 JAPAN following the provision of the EMC Directive (2014/30/EU) and Low Voltage Directive (2014/35/EU).

WARNINGS AND CAUTIONS

Please read the operating instructions in this Owner’s Manual, especially the warnings and cautions, as well as the operating instructions in the camera’s Owner’s Manual (available from the Fujifilm website) in order to operate this product correctly.
After reading, be sure to keep this manual in a safe place where you can refer to it easily.
In order to ensure that this product is used safely and correctly, and to prevent danger to yourself and other persons or damage to property, various icons are used in this Owner’s Manual and on the product. These icons and their meanings are given here. Please read the explanations and get a good understanding of the meaning of each one before you read the main text of this manual.

WARNING

This icon indicates a situation which could result in death or severe injury to persons who disregard these instructions and handle the product incorrectly.

CAUTION

This icon indicates a situation which could result in injury to persons or physical damage to objects, if these instructions are disregarded and the product is handled incorrectly.

Example of Icons

Triangular icons tell you that this information requires attention (“Important”).
Circular icons with a diagonal bar tell you that the action indicated is prohibited (“Prohibited”).
Filled circles with an exclamation mark indicate an action that must be performed (“Required”).

The symbols on the product (including the accessories) represent the following:

AC
DC
Class II equipment (The construction of the product is double-insulated.)

WARNING

Turn the camera off and remove the battery should you notice any abnormalities. Continuing to use the product when it is emitting smoke or unusual odors or otherwise functioning abnormally could result in fi re or electric shock. Contact your Fujifi lm dealer.
Do not allow water or foreign objects to enter the product. Should water fi nd or other foreign matter fi nd its way in, turn the camera off . Continued use could cause fi re or electric shock. Contact your Fujifi lm dealer.
Do not use the product in the bathroom or shower. This can cause a fi re or electric shock.
Do not disassemble or modify (never open the case). Failure to observe this precaution can cause fi re or electric shock.
Should the case break open as the result of a fall or other accident, do not touch the exposed parts.
Failure to observe this precaution could result in electric shock or in injury from touching the damaged parts. Remove batteries immediately, taking care to avoid injury or electric shock, and take the product to the point of purchase for consultation.
Do not place the product on an unstable surface. This could cause it to fall or tip over and cause injury.
Never attempt to use the product while in motion.
Do not touch any metal parts of the product during a thunderstorm. This can cause an electric shock due to induced current from the lightning discharge.
Do not use the product in the vicinity of containers for cosmetics or pharmaceuticals. The contents could spill or otherwise fi nd their way into the product, resulting in fi re, electric shock, or injury.
Do not use in the presence of fl ammable objects, explosive gases, or dust. Failure to observe this precaution could cause fi re.
Do not use the product in locations aff ected by oil fumes, steam, humidity or dust. This can cause a fi re or electric shock.
Do not leave the product in locations subject to extremely high temperatures. Do not expose the product to direct sunlight or fl ame or otherwise subject it to high temperatures. Do not leave the product in locations such as a sealed vehicle or in direct sunlight. This can cause a fi re.
Do not subject the product to physical shocks. Do not subject the product to physical shocks, for example by dropping or knocking it over during transport or use. Failure to observe this precaution could result in product malfunction or impaired performance.
Do not obstruct the exhaust vent by covering it with tape or other objects. Failure to observe this precaution could interfere with cooling or cause product malfunction.
Keep out of the reach of small children. This product could cause injury in the hands of a child.

CAUTION

Do not place heavy objects on the product. This can cause the heavy object to tip over or fall and cause injury.
Avoid direct contact with areas of the product that become hot.
Do not use alcohol, thinner, benzene, or other volatile chemicals to clean the product. This can cause fi re or electric shock.
No naked flame sources such as lighted candles should be placed on the apparatus.
Keep away from equipment sensitive to magnetic fields. This product may affect watches, magnetic stripe cards, and other equipment sensitive to magnetic fields. Failure to observe this precaution could result in malfunction or loss of data.
Dispose of the product in accord with location regulations.

Product Care

To ensure continued enjoyment of the product, observe the following precautions.

Storage and Use
Do not store or use the product in locations that are:

exposed to rain or extremely humid, dirty, or dusty
exposed to direct sunlight or very high temperatures, such as in a closed vehicle on a sunny day
extremely cold
subject to strong vibration
exposed to smoke or steam
exposed to strong magnetic fi elds, such as near a broadcasting antenna, power line, radar emitter, motor, transformer, or magnet
expose the product to prolonged contact with rubber or vinyl or with volatile chemicals such as pesticides
Water and Sand
Exposure to water and sand can also damage the product and its internal circuitry and mechanisms. When using the product at the beach or seaside, avoid exposing the product to water or sand. Do not place the product on a wet surface.
Condensation
Sudden increases in temperature, such as occur when entering a heated building on a cold day, can cause condensation inside the product. If this occurs, turn the product off and wait for droplets to evaporate.
Keep hair and other objects away from product when the fan is operation. Failure to observe this precaution could result in objects becoming caught in the fan.
Because the LCD monitor must kept in the open position while the fan is attached, you will need to be particularly careful not to drop the camera or otherwise subject the LCD monitor to excessive force or physical shocks.
Obstructions in the vicinity of the fan’s exhaust vent will interfere with cooling.
The temperature of the camera may increase depending on the ambient temperature and length of use. The camera may become particularly hot when the fan is removed; due caution is advised.
● Be careful not to touch the product’s connectors. Replace the connector cover to protect the connectors during transport.

Attachment
For more information, see the section on cooling fans in the camera Owner’s Manual available from the Fujifi lm website.

Turn the camera off before attaching or removing the fan. Failure to observe this precaution could result in electric shock or damage to the product.
Be sure the product is securely attached. Failure to adequately tighten the locking screw could create a gap between the fan and the camera that could interfere with cooling. Be sure to tighten the screw if it loosens during use.
Be sure to attach the cooling fan connector cover to the camera when the product is removed.

SPECIFICATIONS

Dimensions (W × H × D) 79.5 mm × 54.2 mm × 24.3 mm/3.13 in. × 2.13 in. × 0.96 in., excluding projections
Weight Approx. 104 g/3.7 oz.
Operating conditions
- Temperature: −10 °C to +40 °C/+14 °F to +104 °F
- Humidity: 10% to 80% (no condensation)
These specifications are subject to change without notice. Fujifilm shall not be held liable for damages resulting from errors in this Owner’s Manual.