tecnoswitch OR253DI AstroEasyplus Astronomical Digital Time Switch User Guide
- June 3, 2024
- tecnoswitch
Table of Contents
tecnoswitch OR253DI AstroEasyplus Astronomical Digital Time Switch
LVD, EMC, RoHS, EN 60730-1, EN 61000-3-2, EN 61000-3-3, EN 60730-2-9 KEY LEGEND Fig.1
-
Manual/ Automatic Mode
-
OK OK
-
Buttons joystick
-
Reset
DISPLAY LEGEND Fig.1 -
Set program (P/ R/L) and 1234567 Day of the week
-
Daylight savings time (summer)
-
88:88 Time set
-
Current state of the segments: black = ON – O white = OFF Each segment indicates a program with a time ranging from I to 30 minutes. Winter Time
-
Manual Mode
-
C1 ON/OFF Channel status: Closed= ON; Open=OFF
-
Settings
FACTORY SETTINGS
Astronomical; Automatic mode; Weekly settings; Winter/Summer automatic time settings; Italian language; 30 minutes programming resolution; 0 minute time correction; Time zone +1; Geographic coordinates: Bari.
ELECTRICAL CONNECTIONS
Install on 35mm DIN bar. Automatic switch-on when connected to the grid.
WIRING DIAGRAM
SWITCH ON/OFF
Press OK for 4 seconds.
AUTOMATIC MANUAL (On/Off) MODE
Press to set MANUAL or AUTOMATIC operation.
SETTINGS
Press the joystick in the middle at least 3 seconds and select using confirm with oK set the year using and confirm with oK-set the month using, presS, set the day using and confirm with OK 9 press Ok to enable automatic summer/ winter time change, otherwise select OFF using and confirm with oK set the hour/minutes using and Contirm wth OK >”T tlashes. Press oK, set the post code by entering the first and last 2 digits and confirm with OK “c” (sunrise and sunset correction) flashes. Press OK “a” flashes. Press OK to set the advance/delay at sunrise usingand confirm with OK> Press Okto set the advance/delay at sunset using and confirm with Ok.
PROGRAMS SETTING
Press the joystick in the middleat least 3 seconds pressand select P confirm
with oK the display shows the astronomical programming. To change it press to
set the relay status ON/OFFpress to set the desired time slot to which the
previously set relay status will be assigned (black segments ON8 confirm with
OK > LU appears. Pressto activate
(ON) / deactivate (OFF) the relay status and repeat the previous operation-> Completed programming, press oK.
PROGRAMMING RESOLUTION
Press the joystick in the middle at least 3 seconds-pressand select R confirm
with ok >set 1 30 minutesconfirm with oK
LANGUAGE
Press the joystick in the middleat least 3 seconds pres and select L > confirm
with ok set It ltalian or En English confirm with Ok.
LOCKING SETTING
Hold down at least 5 seconds, PASS appears confirm with OK pressto set the
first two digits; pressand set the last two digits using
confirm with OK.
To unlock it, press two times insert the PASSWORD confirm with ok . Device
must be installed by a qualified person. For more and detailed information,
see the installer manual at tecnoswitch.com Tecno Switch reserves the right to
make changes to its products in each moment and without further notice. Tecno
Switch declines all responsibility for damage to things or persons derived
from an incorrect or improper use of its products.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>