MeTra JP-APJLJT 12V Accessory Power Installation Guide

June 3, 2024
Metra

MeTra logo Jeep® Accessories
JP-APJLJT 12V Accessory Power
Installation Guide
2012 – 2018 Wrangler JK

JP-APJLJT 12V Accessory Power

MeTra JP APJLJT 12V Accessory Power

  1. Remove cubby or power window switch, and remove screw. Then remove screw from upper storage tray.MeTra JP APJLJT 12V Accessory Power - fig

  2. Lift up on dashboard cover.MeTra JP APJLJT 12V Accessory Power - fig 1

  3. Lift up on dashboard cover.MeTra JP APJLJT 12V Accessory Power - fig 2

  4. Pull HVAC panel, starting from top towards interior.
    Locate the power outlet and unplug OE connector.MeTra JP APJLJT 12V
Accessory Power - fig 3

  5. Connect t-harness and route accessory wires as indicated:
    • Red wire: 12V 5Amp fused (accessory/key) power
    • Black wire: Harness Ground

2018-UP Wrangler JL, 2020-UP Gladiator JT

  1. Unclip and remove the panel below the steering column.MeTra JP APJLJT 12V Accessory Power - fig 5

  2. Using panel removal tool, remove the Start/HVAC panelMeTra JP APJLJT 12V Accessory Power - fig 6

  3. Remove (1) screw holding the accessory panel to the subdash. Locate panel clips and carefully pull each section free; this may require the panel removal tool.MeTra JP APJLJT 12V Accessory Power - fig 7

  4. Locate the power outlet. Disconnect the power outlet harness and connect the accessory power harness to that connector. Insert the other accessory power harness connector into the disconnected plug.

  5. Connect t-harness and route accessory wires as indicated:
    • Red wire: 12V 5Amp fused (accessory/key) power
    • Black wire: Harness GroundMeTra JP APJLJT 12V Accessory Power - fig
8

  6. Reinstall panels in reverse order of removal.

MetraOnline.com
Techical Support:386-257-1187

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals