VOLLRATH 15006 Cutting Blade Assembly Instruction Manual
- June 1, 2024
- VOLLRATH
Table of Contents
VOLLRATH 15006 Cutting Blade Assembly
ASSEMBLY
Wash new blades with warm, soapy water and rinse thoroughly to remove the thin protective oil film. Keep the sharp edge away from you when handling blades
- 1. Remove the pusher head assembly:
Tabletop models : Slide the pusher head off the rod guides.
Wall mount models : Remove the locking pin (J). Lift the handle and slide
the pusher head off the guide rods. Place pin back into the hole on the handle
assembly to prevent loss.
-
* **A** Guide Rods. Guides and align the pusher head onto the blade set.- B Handle. Used to lower and raise the pusher head block * On the guide roor smooth and consistent operation of the pusher head
- D Pusher Head Assembly. Made up of the pusher head block (and “T” handle for tabletop models).
- E Bumpers. Cushions the stop of the pusher head.
- 2. Raise the bumpers approximately 2” (5.0 cm).
- 3. Loosen the thumbscrew and carefully remove the blade assembly. Remove the cutting blade assembly by pressing upwards on the bottom of the side of the blade holder, where the thumbscrew is located.
- Discard the old blade assembly.
- 4. Install the new cutting blade assembly by inserting the tab on the blade holder into the groove in the base, then lowering the blade holder into the seated and flush position in the base. Tighten the thumbscrew.
- 5. Slide bumpers down guide rods to contact base assembly. Position the pusher head assembly onto the guide rods, slowly lower the pusher head assembly, and check the pusher head block to blade alignment.
- 6. Lubricate the guide bar with mineral oil or petrol gel after each use. Do not use cooking oil as it will become sticky and may permanently damage the equipment.
- F Thumbscrew. Used to secure the pusher head block or the blade assembly.
- G Pusher Head Bock. Pushes the food product through the blade set. Specifically sized to match the corresponding blade assembly.
- H Blade Assembly. Houses the blades. Specifically sized to match the corresponding pusher head block
- I Base Assembly. Holds the guide rods and blade assembly.
- J Locking Pin. Secures the pusher head to the handle.
The Vollrath Company, L.L.C.
- 1236 North 18th Street Sheboygan, WI 53081-3201 U.S.A.
- Main Tel : 800.624.2051 or 920.457.4851
- Main Fax : 800.752.5620 or 920.459.6573
- Customer Service : 800.628.0830
- Canada Customer Service : 800.695.8560
Technical Services
- techservicereps@vollrathco.com
- Induction Products: 800.825.6036
- Countertop Warming Products: 800.354.1970
- All Other Products: 800.628.0832
© 2016 The Vollrath Company L.L.C.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>