ClimaRad V1C-C Ventura Instruction Manual
- June 3, 2024
- climaRAD
Table of Contents
Maintenance instructions ClimaRad Ventura V1C-C
Maintenance frequency for filters
When should you replace the filters?
-
With normal use, every 2 years or earlier if the message ‘Filter vervuild’ appears
on the display (for example in homes and offices). -
In the case of intensive use, after 1 year or earlier if the message ‘Filter vervuild’ appears on the display (e.g. for care homes and schools).
Replacing air supply and air output filters
1. Set your device to service mode by holding the key combination above for 8 seconds. All LEDs will light up. Wait 1 minute for the valves to open
2. Remove one of the two side panels of the device.
3. Remove the two black filter caps.
4. Remove both polluted filters and place the new inlet filter (below) and output filter (above).
5. Return the two filter caps to their correct positions.
6. Place the side panel back. Reset the filter hour counter by holding the
key combination above for 6 seconds. The “filter vervuild” notification will
disappear.
Press any button to leave the service mode.
Important: Only reset the filter hour counter if you have replaced the filters
Cleaning the air ducts and the insect mesh
1. Set your device to service mode by holding the key combination above for 8 seconds. All LEDs will light up. Wait 1 minute for the valves to close.
2. Clean the insect mesh at the top and bottom of the unit using your vacuum cleaner.
3. First remove the top grille of the device, then remove one of the side panels.
4. Remove the caps from both air ducts. Clean the duct entrances with a dry
cloth or your vacuum cleaner. Also clean the insect mesh in the upper air
duct. Place the
caps back in the device.
5. Clean the insect mesh on both sides of the convector using your vacuum cleaner.
6. Place the side panel back on the device, then place the upper grille back. Press any button to leave the service mode.
Ordering filters
Order new filters at
www.climarad.nl/filters
ClimaRad B.V. – Lübeckstraat 25 – 7575 EE – Oldenzaal – NL –
tel. +31 541 358130
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>