ClimaRad Ventura V1C-C Instructions

June 3, 2024
climaRAD

_

LOGO_

ClimaRad Ventura V1C-C Instructions

ClimaRad-Ventura-V1C-C-Instructions-PRODACT-IMG

User instructions ClimaRad Ventura V1C

Operating principle ClimaRad Ventura V1C

The ClimaRad Ventura V1C is equipped with sensors for CO , humidity, indoor and outdoor temperature. They 2 measure the air quality and automatically determine the required ventilation for each room. The device also features convectors, allowing the unit to ventilate, heat and (optionally) cool .ClimaRad-Ventura-V1C-C-Instructions-FIG-1

Operating the ClimaRad Ventura V1C

The control panel is situated on the front of the device. You can find the function buttons and notifications of the panel in question on page 2 of this instruction manual. The ClimaRad Ventura V1C in your room is optimally configured by the installer and functions fully automatically. That is why we only explain the function buttons that are relevant for you during daily use.

Operating the ClimaRad Round

You can set the desired temperature yourself by turning the ring. Turn left for lower temperatures, turn right for higher temperatures.

Function Keys

Automatic control: The ventilation, heating and cooling system in the room are automatically controlled by your ClimaRad Ventura, which functions based on CO2 measurements and temperature.

Temperature: You can set the desired temperature yourself using the + and – on your control panel in order to heat up or optionally cool down the room.

Pause: Use this function if you want to stop ventilating temporarily. After a period of 4 hours, your ventilation unit will reset to automatic control.

Ventilation (manual): This function allows you to activate the ventilation function of your device. You can then use the + and – on your control panel to configure the ventilation speed. After a period of 8 hours, your device will reset to automatic control.

No function.

Child lock: This key combination locks your control panel. Press the indicated buttons simultaneously for 4 seconds. If you want to unlock the device, repeat this action.

Messages

Child lock: The child lock is activated.

Error: A fault has occurred. Please contact your installer or housing corporation.

Dirty filter: Replace the air filters or contact your installer or housing corporation After replacing the filters, press the + and – buttons for 6 seconds.

Switch off

Press 4 seconds simultaneously

Press for 6 seconds

ClimaRad B.V. – Lübeckstraat 25 – 7575 EE – Oldenzaal – NL – info@climarad.comwww.climarad.co.uk – tel. +31 541 358130

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals