ClimaRad Ventura V1C Instruction Manual
- June 3, 2024
- climaRAD
Table of Contents
ClimaRad Ventura V1C Instruction
User instructions ClimaRad Ventura V1C
Operating principle ClimaRad Ventura V1C
The ClimaRad Ventura V1C is equipped with sensors for CO , humidity, indoor
and outdoor temperature. They 2 measure the air quality and automatically
determine the required ventilation for each room. The device also features
convectors, allowing the unit to ventilate, heat and (optionally) cool
.
Operating the ClimaRad Ventura V1C
The control panel is situated on the front of the device. You can find the function buttons and notifications of the panel in question on page 2 of this instruction manual. The ClimaRad Ventura V1C in your room is optimally configured by the installer and functions fully automatically. That is why we only explain the function buttons that are relevant for you during daily use.
Operating the ClimaRad Round
You can set the desired temperature yourself by turning the ring. Turn left for lower temperatures, turn right for higher temperatures.
Function Keys
Automatic control: The ventilation, heating and cooling system in the room are automatically controlled by your ClimaRad Ventura, which functions based on CO2 measurements and temperature.
Temperature: You can set the desired temperature yourself using the + and – on your control panel in order to heat up or optionally cool down the room.
Pause: Use this function if you want to stop ventilating temporarily. After a period of 4 hours, your ventilation unit will reset to automatic control.
Ventilation (manual): This function allows you to activate the ventilation function of your device. You can then use the + and – on your control panel to configure the ventilation speed. After a period of 8 hours, your device will reset to automatic control.
No function.
Child lock: This key combination locks your control panel. Press the indicated buttons simultaneously for 4 seconds. If you want to unlock the device, repeat this action.
Messages
Child lock: The child lock is activated.
Error: A fault has occurred. Please contact your installer or housing corporation.
Dirty filter: Replace the air filters or contact your installer or housing corporation After replacing the filters, press the + and – buttons for 6 seconds.
Switch off
Press 4 seconds simultaneously
Press for 6 seconds
ClimaRad B.V. – Lübeckstraat 25 – 7575 EE – Oldenzaal – NL – [email protected] – www.climarad.co.uk – tel. +31 541 358130