origo FH9515 Ceramic Heater Instruction Manual
- June 3, 2024
- origo
Table of Contents
FH9515 Ceramic Heater
Instruction Manual
FH9515 Ceramic Heater
- Read all instructions carefully before using the FAN HEATER, and keep this instruction for furture reference when necessary.
- This instruction manual can be acquired at www.origin.hk.
Important Safety Information
-
Read all instructions carefully before using the Heater.
-
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible or their safety. Children should be supervised to ensure that they do not play with the appliance.
-
Use this Heater on a horizontal and stable surface.
-
If the supply cord is damaged, it must be replaced by manufacturer, its service agent or similary qualified persons in order to avoid a hazard.
-
WARNING: Do not use this Heater in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
-
Do not use this Heater if it has been dropped.
-
The Heater must not be located immediately below a socket outlet.
-
The Heater is not intended to be operated by means of an external programmer, timer,seperate remote-control system or any other device that switches the Heater on automatically, since a fire risk exists if Heater is covered or positioned incorrectly.
-
WARNING: In order to avoid over heating, do not cover the Heater. The Heater is hot when in use. To avoid burns, do not let bare skin touch hot surface.
-
WARNING: To reduce the risk of fire, keep textiles, curtains, or any other flammable material a minimum distance of 1m from the air outlet and inlet of the Heater.
-
Do not use if there are visible signs of damage to the Heater.
-
The Heater must NOT be used in potentially dangerous location such as flammable explosive, chemicalladen or wet atmospheres.
-
Heater is intended for household use ONLY, not for industrial or outdoor use.
-
Remove the package and ensure that the Heater is undamaged. In case of doubt do not use the Heater and contact your supplier.
-
Do not let children play parts of package.
-
Before using the Heater, check if the voltage marked on the rating label corresponds to the mains in your home.
-
Avoid using extension cord as the extension cord may overheat and casue fire.
-
Do not pull the power cord to disconnect with power source. Always grasp the plug to pull out.
-
WARNING: The Main Power Switch and the On/Off switch should not be used as the sole means of disconnecting power.
-
WARNING: To avoid danger of electric shock, unplug from outlet when not in use and before cleaning.
-
The Heater is not intended for use in the immediate surroundings of a basin, a bath, a shower, a swimming pool, a wet or damp locations.
-
Do not insert any objects into the Heater as it may cause an electric shock or fire or damage to the Heater. Do not block or tamper with the Heater in any manner while it is in operation. To prevent a possible fire, do not block air inlet or oultet in any manner. Do not place on soft surfaces, like a bed, where opening may become blocked.
-
The Heater includes an overheat protection, when the Heater are overheated, it will stop working automatically, please immediately turn the Heater off and inspect the Heater.
-
This product contains recyclable materials. Do not dispose this product as unsorted municipal waste. Please contact your local municipality for the nearest collection point.
Main Parts
|
---|---
The picture is for reference only, everything in kind shall prevail.
Function Setting
NOTE: For first time operation, there will have some smell for about few
minutes.
Because this Heater have some protective oil on the surface of the heating
element.
The Heater may be operated by the control panel located on the Heater.
-
Carefully remove the Heater from the plastic bag and the carton.
-
Place the Heater on a stable flat surface.
-
Set the Main Power Switch to ‘OFF’ position. Plug the Power Cord into a a.c. 220-240V electrical outlet. Press the Main Power Switch to ‘ON’ position. The Heater will have a”beep” sound, the Heater is ready to use.”
-
On/Off: Press the” ” key, the Heater is starting to preperation mode and show the current room temperature.
-
Heating: Press the” ” key, the Heater will start at Low Heat, the display light will turn red and the LED will display the current room temperature. If the room temperature is higher than the preset temperature‘25℃’, Heater will not working. Press this key again to set the Heater into High Heat.
-
Fan: Press the” “key to set the Heater into Fan Mode, the display light will turn blue.
-
Timer(Shut-off): When the Heater is ON, press the” “key to increase or descrease the length of operation from 0.5-24 hours.
-
OSC : Pressing the” “key will allow the Heater to oscillate the wind direction. To stop the oscillation, press this key again.
-
SET TEMP : When the unit is in the LOW HEAT or HIGH HEAT MODE:
9.1. Press the”+”key to increase the desired temperature and the”-” key to decrease the desired temperature. Working temperature: 5-35℃.
9.2. When the air temperature reaches the ‘SET TEMP’, the Heater will cut off.
9.3. When the air temperature drops below the ‘SET TEMP’, the Heater will back on.
9.4. Note: It is normal for the Heater to cycle ON and OFF as it maintains the ‘SET TEMP’. -
OFF: To turn the Heater off, press the” “key. The FAN will work for 60 seconds to cool down the Heater and then turn OFF.
* Note:** When the Heater is tipped over, the tipping device makes a sound, which is a normal phenomenon.
Safety Features
- A thermal overload protector is built-in to prevent overheating.
- When the Heater is overheat, it will be shut off automatically. To RESET the Heater:
2.1. Unplug the Heater and wait for 30 minutes to cool down.
2.2. Turn ON the Heater again to resume operation.
Maintenance
WARNING: ALWAYS UNPLUG THE POWER CORD BEFORE MOVING OR SERVICING. DO NOT
IMMERSE THE HEATER IN WATER! MAKE SURE THE HEATER IS COMPLETELY COOL DOWN
BEFORE CLEANING
CLEANING: Clean the Air Inlet with the vacuum brush attachment on your
vacuum cleaner. Clean the body of the Heater with a soft cloth.
If the Heater is used frequently, the activated carbon filter needs to be
cleaned every month.
CAUTION: Do NOT use gasoline, benzene, thinner, harsh cleaners, etc., as
they will damage the Heater. NEVER use ALCOHOL or any other SOLVENTS.
STORAGE: Store the Heater with these instructions in the original box in
a cool and dry place.E THE HEATER IN WATER!
Specifcation
Model Number | FH9501 |
---|---|
Power Supply | 220-240V~ 50-60Hz |
Rated Power | 2000W |
Product Dimension | 180 x 180 x 375 mm (Approx.) |
Origin Map
OFFICE
HOURS
10:30am – 12:30pm (Mon to Fri)
02:30pm – 05:30pm (Mon to Fri)
10:30am – 12:30pm (Saturday)
(Closed on Sunday and Holiday)
Warranty Card(1 year carry-in)
Item : Ceramic Heater
Model : FH9515
This product is warranted for 1year (commercial use for 3 months) from the
date of purchase under the following conditions:
-
For any defect, in the judgment of our technician, if it is caused under normal use, we are responsible for repairing the product, and/or replacing parts at free of charge.
-
This warranty DOES NOT apply to:
– If the product has been damaged through abuse, misuse, negligence or accidents;
– Unauthorized repair, alteration/modification;
– The housing, cover or accessories, is excluded from this warranty. -
The customer is requested to bring the unit to and from our Service Centre whenever service is needed.
-
Any defective parts, which had been replaced, shall be of our property.
-
This warranty is valid in H.K.S.A.R. only.
-
Please show the Invoice to get free service.
***Extra 3 months warranty: just complete Online Warranty Registration within 10 days from the date of receipt, free warranty will be extended to 15 months (not applicable to commercial use). Plaese enter our website: www.origo.hk
Service Centre
ORIGIN MARKETING LIMITED
Unit H, 21/F., Reason Group Tower (nearby 12 Wah Sing Street),
403 Castle Peak Road, Kwai Chung, N.T., Hong Kong.
Tel: 2156 8238http://www.origo.hk
https://www.facebook.com/Origin-Marketing-Limited-327710507631440/
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>