newtech milu odourless PIR Motion Sensor 12V Instruction Manual
- June 3, 2024
- Newtech
Table of Contents
milu
odourless by expella exclusive to Newtech
Installation Instructions
Milu PIR Motion Sensor, 12V
PRODUCT OVERVIEW
The Expella PIR motion sensor incorporates advanced technology to automatically activate a Milu odourless toilet when motion is detected. The sensor field of view has been designed to function within a small space to isolate the operating zone to a 2m range. This minimises false triggers. Once motion is detected the odourless fan switches on. While motion is present the fan stays on. When no motion is present, the fan runs on for a period of 5 minutes efore turning off.
Tools Required
– 70mm hole saw
Procedure
The PIR Motion sensor installs electrically in-line with the odour control fan
and fan power supply (transformer)
Locate a position in the ceiling above the toilet. The sensor should be
located within a 0.35 meter radius above the toilet pan. Ensure there are no
structural members in this location that inhibit installation. Location should
be in reach of the 12V transformer cable and fan power cable/connector used to
power the odourless toilet.
Locate hole in ceiling 0.35m radius above toilet centre
Feed cables through the hole and install in Ceiling
TEST OPERATION
- Turn on power supply. Fan will start
- Leave the room and wait for fan to turn off (approx. 5mins)
- Enter room and move in to sensing region (approx. 0.5m radius from sensor)
- Fan should turn on again for 5 mins
- Sensor may need rotating in the ceiling to better align with the target
SPECIFICATION
Input/Output Voltage | Current (max) | Sensor Range | Run on time period |
---|---|---|---|
9-12 VDC | 1.5 A | 0.5m Radius | 5 mins |
DIMENSIONS
Head Office & Distribution Warehouse
281 Heads Road, Whanganui
06 349 0194 or 0800 728 662
sales@newtech.co.nz
www.newtech.co.nz
www.newtech.co.nz | 0800 728 662 |
sales@newtech.co.nz
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>