newtech Freestanding and Back to Wall Baths Instruction Manual
- June 4, 2024
- Newtech
Table of Contents
Freestanding and Back to Wall Baths
Instruction Manual
Freestanding and Back to Wall Baths
IMPORTANT: Please read the following instructions carefully before commencing installation. Qualified tradesmen must carry out all plumbing works and all aspects of the installation process should be in accordance with the building code.
FREESTANDING AND BACK-TO-WALL BATH
Installation Instructions
For optimum results, the bathroom floor should be level. To aid the
installation the use of a low-profile 2-piece bath waste is recommended.
Refer to Newtech Evoke 2-Piece 40mm Bath Waste – Product Code: 2280.
-
Newtech baths are supplied with integrated support with adjustable feet. Place the bath in the desired position. Note: Waste placement and plumbing requirements should have been determined and prepared by this stage. Once in the desired position adjust the bath feet so that the baths surround is touching the floor.
-
Using the spirit level check to ensure the top edge of the bath is level. If necessary, use the leveling feet to adjust. Adjusting the feet will cause the acrylic surround to lift off the floor.
BATH INSTALL DETAIL LEG
-
Carefully tilt the bath backward and apply an appropriate adhesive to each of the bath feet.
-
Connect the waste and lower the bath into position.
-
As an option, once the bath is in its final position the acrylic surround may be sealed to the floor using sanitary grade silicone. Leave to cure for a minimum of 24 hours with no water.
Additional installation instructions for Newark/Indus Back-to-Wall Baths or Park Avenue Bath.
INSTALLING WITHOUT AN UPSTAND – TILES
NOTE: This method is not to be used in a shower-over-bath situation
INSTALLING WITHOUT AN UPSTAND – WALL LINING
NOTE: This method is not to be used in a shower-over-bath situation
INSTALLING WITH AN OPTIONAL UPSTAND
NOTE: When installing a shower over a bath, an upstand must be installed
in accordance with the NZ Building Code.
DO NOT RUN WATER UPON INSTALLATION FOR 24 HOURS
Newtech warrants that products or product components manufactured and
distributed by Newtech:
- meet or exceed the standard requirements of the New Zealand Building Code; and
- will be free from inherent defects in materials and workmanship for the extended warranty period applicable to the product.
Newtech will provide a replacement product or replacement part (or the nearest
equivalent) free of charge where a product is covered by our warranty. Any
remedial works will not be covered by Newtech.
The Newtech warranty will not apply where the product has been improperly
installed, has been misused, proof of purchase cannot be provided, or where
the warranty claim has not been notified to Newtech within three months of the
problem first appearing.
For further information, please read the Newtech Warranty document at
newtech.co.NZ.
Our 5-year warranty offers our customers peace of mind knowing Newtech
products are free of defects, both in materials and workmanship.
Head Office
281 Heads Road, Wanganui
PO Box 2050, Wanganui
sales@newtech.co.nz
Auckland Showroom
525 Great South Road, Penrose, Auckland
aucklandshowroom@newtech.co.nz
0800 728 662
www.newtech.co.nz
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>