EPSON ET-2810 All-in-One Ink Tank Printer User Guide

ET-2810 All-in-One Ink Tank Printer

EN Start Here TC

MN

© 2022 Seiko Epson Corporation Printed in XXXXXX

Read This First The ink for this printer must be handled carefully. Ink may splatter when the ink tanks are being filled or refilled with ink. If ink gets on your clothes or belongings, it may not come off.

. . .

Windows
Additional items may be included depending on the location. .
The initial ink bottles will be partly used to charge the print head. These bottles may print fewer pages compared to subsequent ink bottles. . .

1

A

USB

2
Follow these instructions if you selected “No” in section1- B. 1- B 1- B “” .
A
Make sure that the color of the ink tank matches the ink color that you want to fill. .
B
O Remove the cap while keeping the ink bottle upright; otherwise ink may leak.
O Use the ink bottles that came with your product. O Epson cannot guarantee the quality or reliability of non-genuine
ink. The use of non-genuine ink may cause damage that is not covered by Epson’s warranties. O O O Epson Epson O ; , . O . O Epson . Epson- .

O When you insert the ink bottle into the filling port for the correct color, ink starts pouring and the flow stops automatically when the ink reaches the upper line.
O If the ink does not start flowing into the tank, remove the ink bottle and reinsert it. However, do not remove and reinsert the ink bottle when the ink has reached the upper line; otherwise ink may leak.
O Ink may remain in the bottle. The remaining ink can be used later. O Do not leave the ink bottle inserted; otherwise the bottle may be
damaged or ink may leak.
O
O
O O

O .
O , . , ; .
O . .
O . .
E When the ink reaches the upper line of the tank, pull out the bottle. .
BK

J Confirm that the tanks are filled with ink, and then hold down the button for 5 seconds to start charging ink. Charging ink takes about 11 minutes.

11

5

5 . 11 .

Off. .

Flashing. .

On. .

Flashing. .

On. .

N The nozzle check pattern is printed. Check the printed pattern to see if the print head nozzles are clogged.
. .

K Load A4 size plain paper at the center of the paper support with the printable side facing up. A4 4 .

ET-2810 Series / L3250 Series

O

P

ET-1810 Series / L1250 Series

O Run the print head cleaning. Print head cleaning uses some ink from all ink tanks.
. .

F

B Select the printer setup method. .
Do you have a smart device? ?

No. .

Yes. .

Go to section 2. 2 2- .

Hold down the button until it flashes. Then use your smart device to complete the rest of the setup process.
. .

Epson Smart Panel

Epson Smart Panel

Install Epson Smart Panel. This will help you set up the printer even if you use the printer with a computer.
Epson Smart Panel
Epson Smart Panel . .

You can set up the printer while watching instructions on your smart device. By using the app, you can remotely control the printer on your smart device or perform more diverse printing through the app.

. .

C Check the upper line in the ink tank. .

Upper line

G

D Insert the ink bottle straight into the port to fill ink to the upper line. .
H

I

K

L Press the button to turn off the printer. .

M Print a nozzle check pattern to check if the print head nozzles are clogged. .
While holding down , press .
– – .

Flashing alternately. .

On. .

P If there is ink remaining in each bottle, refill the ink tank. See steps A to H in section 2. 2 A H . 2- A­H .
Q Visit the website or use the CD supplied for Windows users to install software and configure the network. When this is complete, the printer is ready for use. Windows CD , Windows CD- . . http://epson.sn

Guide to Control Panel

Buttons and Functions
Turns the printer on or off.

Clears a network error. Hold down for 5 seconds or more to make network settings using the WPS push button.

Prints a network connection report to determine the causes of any network problems. To get more information, hold this button down for more than 7 seconds to print a network status sheet.

*1 Starts monochrome or color copying on A4 size plain paper. To increase the number of copies (by up to 20 copies), press this button within 1 second intervals.

Stops the current operation. Hold this button down for 5 seconds until the button flashes to run print head cleaning.

*1

Check Scanned Images: Press the and

buttons simultaneously to run software on a USB-

connected computer and check scanned images.

*1 Copy in Draft Mode: Press the and the or buttons simultaneously to copy in draft mode. For users in Western Europe, draft mode is not available.

PIN Code Setup (WPS): Hold down the

and

buttons simultaneously to start PIN Code Setup

(WPS).

Wi-Fi Direct (Simple AP) Setup: Hold down the and buttons simultaneously to start Wi-Fi
Direct (Simple AP) Setup.

Restore Default Network Settings: Turn the printer on while holding down the button to restore the default network settings.
When the network settings are restored, the printer turns on and the network status lights flash alternately.

Print Nozzle Check Pattern: Turn the printer on while holding down the button to print the nozzle check pattern.

*1 : Only for ET-2810 Series and L3250 Series.

Reading the Indication Lights

: On

: Flashing

Normal Status
The printer is connected to a wireless (Wi-Fi) network.

The printer is connected to a network in Wi-Fi Direct (Simple AP) mode.

Error Status

Wi-Fi connection error has occurred. Press the the error and try again.

button to clear

Initial ink charging may not be complete. See section 2 on the front page to complete initial ink charging.
No paper is loaded or more than one sheet has been fed at a time. Load paper and press the or button.
A paper jam has occurred. Remove the paper and press the or button. See the “Clearing Paper Jam” section. If the indicator light
continues flashing, see the jammed paper section from “Solving Problems” in the User’s Guide.
The printer was not turned off correctly. After clearing the error by pressing the or button, cancel any pending print jobs. We recommend performing a nozzle check because the nozzles may have dried or clogged. To turn off the printer, make sure you press the button.
Flashing simultaneously: An ink pad is nearing or at the end of its service life. Flashing alternately: A borderless printing ink pad is nearing or at the end of its service life. Borderless printing is not available, but printing with a border is available. To replace the ink pad or borderless printing ink pad, contact Epson or an authorized Epson service provider.
The printer has started in recovery mode because the firmware update failed. For more details, see the error indicator table from “Solving Problems” in the User’s Guide.
A printer error has occurred. Remove any paper inside the printer. Turn the power off and on again. If the error continues to occur after turning the power off and on again, contact Epson support.

5 WPS 7
*1 A4 ( 20 ) 1
5

*1

USB

*1

PIN (WPS) PIN (WPS)

Wi-Fi Direct (Simple AP) Wi-Fi Direct (Simple
AP)

*1 ET-2810 L3250

(Wi-Fi)

Wi-Fi Direct (Simple AP)

Wi-Fi

2

Epson Epson

Epson

, .

. WPS 5 .

. 7 .

*1 4 . (20 ) 1 .

. 5 .

*1

: USB

,

.

*1 : . .

(WPS):

(WPS)

.

: .
*1 : ET-2810 L3250 .

:

:

(Wi-Fi) .

Wi-Fi Direct ( AP) .

Wi-Fi . .

. 2- .
, . .
. . ” ” . ” “- .
. . . .
: . : . , . Epson Epson- .
. ” “- .
. . , . Epson .

Copying / /
Only for ET-2810 Series and L3250 Series. ET-2810 L3250 ET-2810 L3250 .
A

B C

D Press the or button to start copying. .

Checking Ink Levels and Refilling Ink / /
Check the ink levels. If any of the ink levels are below the lower line, see steps A to H in section 2 to refill the tank. 2 A H
. 2- A­H .

D Close. For safety, the unit is closed in two steps. . , .
The unit must be closed completely before it can be opened again. .

To confirm the actual ink remaining, visually check the ink levels in all of the printer’s tanks. Prolonged use of the printer when the ink level is below the lower line could damage the printer.

. .

Ink Bottle Codes / /

For Asia / /

BK

C

M

Y

003

Use of genuine Epson ink other than the specified ink could cause damage that is not covered by Epson’s warranties. Epson Epson
Epson- Epson- .

E
Troubleshooting / /
See the online User’s Guide for detailed information. This provides you with operating, safety, and troubleshooting instructions such as clearing paper jams or adjusting print quality. You can obtain the latest versions of all guides from the following website. . , , . .

Clearing Paper Jam / /
A
B

http://epson.sn
Support / /
For outside Europe / /
http://support.epson.net/
Storing and Transporting / /
A

B C
C

D
O Be sure to keep the ink bottle upright when tightening the cap. Place the printer and the bottle in a plastic bag separately and keep the printer level as you store and transport it. Otherwise ink may leak.
O If print quality has declined the next time you print, clean and align the print head.
O
O
O . , , . .
O , .
Information for Users in Taiwan Only /
L3250/L3256
O O AC 100 – 240 V O 50 – 60 Hz O
12 W 4.5 W 0.7 W 0.2 W O 0.4 – 0.2 A , O O 5760×1440 dpi O Windows Vista®, Windows® 7, Windows 8/8.1, Windows 10(32-bit, 64-bit) Windows XP SP3(32-bit) Windows XP Professional x64 Edition SP2 Windows Server® 2003(SP2) ( ) Mac OS X 10.6.8 Epson O O O O SEIKO EPSON CORPORATION 3-5, Owa 3-chome, Suwa-shi, Nagano-ken 392-8502 Japan 81-266-52-3131 10015 (02) 8786-6688 () O O URL : http://www.epson.com.tw/TW_RoHS NCC

Windows® is a registered trademark of Microsoft Corporation.
The contents of this manual and the specifications of this product are subject to change without notice.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>