ZUBARR S90 Folding 3 In 1 Wireless Charger User Manual
- June 3, 2024
- ZUBARR
Table of Contents
Folding 3-in-1 Wireless
ChargerUser Manual
Note: Please use QC3.0 or above adapter
Product Description
This product is a three-in-one multifunctional wireless charger, supporting iphone14/13 series phones, iwatch, Airpods and other devices that support QI standard.Airpods and other devices that support QI standard. It is a convenient and practical smart electronic device, this product supports multipleThis product supports multiple devices charging at the same time.
For Cell Phone
iPhone14(Plus/Pro/Pro max),
iPhone13&12 series(Pro /Pro Max),
iPhone11(Pro/Pro Max),
iPhone SE(2gen),
iPhone X(XR/XS/Max),
iPhone(8/Plus)
For Watch
8/Ultra/SE,7,6,SE,t,4,3,2 (1 generation not supported)
For Earphone
Airpods Pro 2,Airpods Pro,3 generation,2 generation Other TWS earpods
Other Phones That Support Ql Charging
Product Specifications
Input: 9V/2A, 12V/2A
Output: 1.Phone: 1tW
2.Watch: 2.tW
3.Earphone: 3W
Standard Accessories
3-in-1 wireless charger1
Typec-C type cable1
ser manual*1
FCC WARNING
This device complies with part 1t of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 1t of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- lncrease the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum 20cm distance between the radiator and your body: Use only the supplied antenna.
The LED light turns blue and green flashing during wireless charging to
indicate charging failure
The following conditions can cause malfunctions, such as slow charging in the
charging position, stopping charging and over temperature.
- The adapter is not up to standard (no computer USB output power).
- The charging cable is not up to standard.
- Smartphones do not support wireless charging capabilities.
- There is metal on the back of the phone.
Attention
- Keep the charger away from water or other liquids.
- lf you need to clean the charger, make sure it is not connected to the power supply.
- Use the ambient temperature to maintain again 0~45℃.
- Please use a 0 or higher adapter to charge your phone, headset and watch at the same time.
MADE lN CHlNA
3-in-1 Wireless Charger User Manual
Thank you for purchasing our products Please read the manual carefully
before use
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>