EVOLVEO GEH6064 LED Roadway Light Installation Guide
- June 3, 2024
- Evolveo
Table of Contents
EVOLVEO GEH6064 LED Roadway Light
WARNING
RISK OF ELECTRIC SHOCK
Risk of electrical shock. Disconnect power before service installation, or
maintenance of the product.
RISK OF INJURY OR DAMAGE
Unit will fall if not installed properly. Follow installation instructions.
CAUTION
RISK OF INJURY
Risk of electrical shock. Disconnect power before service installation, or
maintenance of the product.
RISK OF INJURY
The luminaire should be mounted so that prolonged staring into the luminaire
at a distance closer than 0.50m is not expected.
Storage & Handling
- Store packaged units in a covered dry area
- Check for damage
- Do not impact
- Do not stack
Mounting
- Unless captive, unhinge and remove the door.
- Open the clamp to pipe OD.
- Remove the bird shield for the large pipe.
- Install with LEDs facing down.
- Insert pipe thru housing.
- Start pipe on the middle step.
- Shift steps to level fixture front-to-back.
- Rotate to level side-to-side.
- Once level, tighten bolts evenly.
WARNING
RISK OF DAMAGE
Do not torque bolts greater than 12 ft-lbs. Damage may occur.
Wiring
- Extend wires past pipe
- Secure wires in the terminal block.
- Connections for wired external dimming.
CAUTION
RISK OF SHOCK OR DAMAGE
Follow applicable national and local electrical codes.
RISK OF DAMAGE
Verify supply voltage and wire insulation temperature rating match nameplate
requirements.
Photoelectric Control
- Rotate the receptacle to aim “N” to the North.
- Lift, rotate, release, and press to the seat.
- Insert, twist to lock.
Door Closing
- Hang the door on the hinge, and rotate it closed.
- Close and fasten the door.
Cleaning
Use mild soap/detergent. Rinse with cool low-pressure water. Wipe dry with a
clean soft cloth.
CAUTION
RISK OF DAMAGE
Do not use soap/detergent containing aromatic hydrocarbons.
Specifications
Selected SKU’s 50°C. See Datasheet
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
This Class [A] RFLD complies with the Canadian standard ICES-005.
Note:
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed
to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required
to correct the interference at his own expense.
These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation, operation, or maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s purposes, the matter should be referred to Current.
© 2022 Current Lighting Solutions, LLC. All rights reserved. GE and the GE monogram are trademarks of the General Electric Company and are used under license. Information and specifications are subject to change without notice. All values are designed or typical values when measured under laboratory conditions.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>