midocean MO6672 Shower Timers User Manual
- June 3, 2024
- midocean
Table of Contents
midocean MO6672 Shower Timers
How to use
- There is one “Start” button on the countdown timer, the button controls the start/stop of the timer.
- When the shower timer shows 0m00s, press the” Start” button, and the timer will reset to 5m00s, press the” Start” button again to pause the countdown.
- During the pause, press the” Start” button again to resume the countdown from the pause.
- When the timer reaches 0m00s on the countdown display, the alarm will be set off and will ring for 1 minute if it is not manually stopped.
- When the alarm is ringing, press ”Start” to stop the alarm.
Function
- The shower timer is splashproof only. DO NOT submerge the timer fully in water.
- Suction cups will only allow the item to stick on smooth surfaces. Please lightly wet the smooth surface for a better suction result.
- When the display is dim, please change the battery.
Battery specification
- The timer included one AG10 battery.
- To change the battery, open the battery door on the back of the timer. The battery door can be opened with a coin, twist the battery door in a counter-clockwise direction until the dot on the battery door aligns with the dot on the timer to open the battery door.
- Close the battery door by lining up the 2 dots to each other, Then turn the battery door with a coin in a clockwise direction to close the battery door.
Make sure the battery door is closed tightly for the best splash-proof function.
Hereby, MOB, declares that item MO6672 is in Compliance with the essential
requirements and other relevant conditions of Directive 2014/30/EU. The full
text of the EU declaration of conformity is available at the following
internet address:
www.momanual.com.
MOB, PO BOX 644, 6710 BP (NL).
PO: 41-XXXXX
Made in China.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>