BlendMount BBE-2017 Custom-Fit Radar Detector Mount Instruction Manual
- June 3, 2024
- BLENDMOUNT
Table of Contents
BlendMount BBE-2017 Custom-Fit Radar Detector Mount
Your rear view mirror has a minimal clearance between the back side of the mirror and the mirror stem. It is very important that this mount Is Installed correctly to ensure mirror adjustability Is retained. PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE INSTALLING THIS MOUNT
NOTE: For Illustration purpoau, the mount and rear view mirror shown In the may look lightly different then YOUR mount and rear viaw mirror
Before installing this mount on your minor observe how the spring clip functions. When used properly, the spring clamp avoids putting excessive pressure on the miror when Installing and removing the radar detector (RD}. To release tension from the sping clip. simply squeeze the tab and the back side of the mount together. This will lower the bottom portion of the spring clip allowing you to slide the RD on and off the mount. Push the RD Release button and slide the RD onto the Spring Clp until you hear t lock Into position, then release both the Tab and Release Buton. Install and remove the RD a few times before Installing the mount on your memory. Once the Installation le complete, the spring clip allows you to access the buttons an top of the RD while still having the RD installed to sit as close ta the bottom of the rear-view mirror as possible. By gently pushing down on the RD the spring clip is designed to flex downward allowing you to push desired buttons, then it will spring back into its original position when you take your finger away. This can also be usefull to access the release button.
- STEP 1-Loosen the clamp screw so the top section separates from the section. This well provides the necessary clearance to side the mount over the mirror stem as shown above. Adjust the mirror parallel to the windshiold and alightly upward for ease of installation.
- STEP 2- BEFORE FULLY TIGHTENING THE CLAMP SCREW, MAKE SURE THE TOP AND MID SECTIONS ARE TOUCHING AT THE PVOT POINT. I you can not get them to touch at the pivot point, you have an incompatible mirror type for this mount.
- STEP 3 Position the mount as far forward as you can. Tighten the clamp scraw until the Top and Mld Sections are slightly snug and the motor stem. You should sill be able to rotate the mount.
- STEP4- Rotate the mount so t le parallel with the bottom of the minor. Tighten the clamp screw untill the mount Is securely attached to the memory stem. Do not over tlghten the camp Screw.
- STEP 5- Install your radar detector onto the mount. Use the adjustments shown above to adjust the RD to your desired position. We recommend ad using the RD as close to the bottom of your mirror as you can. Be sure to tighten the vertical and pivot adjustment screws after the adjustments are made. For the Plvoi adjustment, grab the long am of the Allen wrench for maximum leverage. You wll not strp the threaded holes In the aircraft grade aluminum.
CAUTION
DO NOT use thls mount fit It Interferes wlth the adjustability or the
operation of your rear view mirror In any way. DO NOT use thls mount If the
radar detector creates an unsafe viewing obstruction. DO NOT ATTEMPT TO MODIFY
THIS PRODUCT. Consult the manufacturer for assistance. All BlendMaunt products
are accompanied with detailed Installation instructions and adjustment tips.
You are encouraged to contact
[email protected] or
call J28 Design at 1-888-497-8388 for
further assistance.
Check the BlendMount Forum for Installation tips and some vehicle specific Instals. www.blendmount.com
Your feedback ls very important to us. Please emall any questions or comments you have to [email protected]
BlendMount-US PATENT# D625,580 S, 0656,811 S, 0653,980 S and other patents pending